Difficulty

Moderate

Steps

11

Time Required

                          20 minutes

Sections

2

  • Disassembling General Electric Bagel Switch 4-Slice Toaster Outer Case
  • 3 steps
  • Power Supply
  • 8 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackGeneral Electric Bagel Switch 4 Slice

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Disassembling General Electric Bagel Switch 4-Slice Toaster Outer Case
  • Unplug the toaster from the electrical outlet.

Unplug the toaster from the electrical outlet.

1024

Step 2

  • Remove the two levers and four dials by pulling them out directly towards you.
  • Removing these components may require some force, but they will release.

Remove the two levers and four dials by pulling them out directly towards you.

Removing these components may require some force, but they will release.

Step 3

  • Look for the plastic clips on the back side of the toaster.
  • Disconnect the small plastic clips on the back of the toaster. Use Philips head Screwdriver to do this step.
  • Now, carefully remove the toaster casing.

Look for the plastic clips on the back side of the toaster.

Disconnect the small plastic clips on the back of the toaster. Use Philips head Screwdriver to do this step.

Now, carefully remove the toaster casing.

Step 4

              Power Supply
  • Flip the toaster over so that the bottom plate is facing up.

Flip the toaster over so that the bottom plate is facing up.

Step 5

  • Remove the four screws from the bottom of the toaster.

Remove the four screws from the bottom of the toaster.

Step 6

  • Carefully separate the bottom plate from the metal components inside the toaster.

Carefully separate the bottom plate from the metal components inside the toaster.

Step 7

  • Using wire cutters, cut the power supply cable close to the base of the toaster, leave about 2 inches of wire.

Using wire cutters, cut the power supply cable close to the base of the toaster, leave about 2 inches of wire.

Step 8

  • Pull the power supply cord through the bottom plate of the toaster.

Pull the power supply cord through the bottom plate of the toaster.

Step 9

  • Insert the end of the new power supply cable through the hole in the bottom plate.

Insert the end of the new power supply cable through the hole in the bottom plate.

Step 10

  • Strip about an inch of the wire insulation (casing) off the ends of both the new power supply cable, and the old power supply cable that is still attached to the toaster.

Strip about an inch of the wire insulation (casing) off the ends of both the new power supply cable, and the old power supply cable that is still attached to the toaster.

Step 11

  • Splice the stripped ends of wire together using a wire cap.

Splice the stripped ends of wire together using a wire cap.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 8 other contributors 


                    Ron Gajdos

Member since: 10/16/2013

307 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       UMass Dartmouth, Team 4-4, Vijaybhaskar Fall 2013                        

                                                  Member of UMass Dartmouth, Team 4-4, Vijaybhaskar Fall 2013 



                    UMASSD-VIJAYBHASKAR-F13S4G4                     


                                            3 Members                     


                                            4 Guides authored