Ge Carescape R860 Display Unit Disassembly Repair Guide

Difficulty

Moderate

Steps

12

Time Required

                          25 minutes            

Sections

1

• GE Carescape R860 Display Unit Disassembly
• 12 steps

Flags

0

• BackGE Carescape R860

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Many replacements and fixes involving the display unit will require removing the rear housing, so this guide will help begin multiple replacement processes.

For additional information regarding disassembly of the display unit, see section 9.5.1 (pg. 249) of the GE CARESCAPE R860 Technical Reference Manual.

What you need

Step 1

              GE Carescape R860 Display Unit Disassembly               

• Using an opening tool, gently pry the alarm light lens (boxed) from the display unit.

Using an opening tool, gently pry the alarm light lens (boxed) from the display unit.

1024

Step 2

• Loosen the seven screws that hold the rear housing using a Phillips #0 screwdriver.
• Remove the rear housing.

Loosen the seven screws that hold the rear housing using a Phillips #0 screwdriver.

Remove the rear housing.

Step 3

• Cut the cable tie holding the two cables at the lower right side using scissors.

Cut the cable tie holding the two cables at the lower right side using scissors.

Step 4

• Disconnect the touch controller cable.

Disconnect the touch controller cable.

Step 5

• Disconnect the Keypad harness at the Carrier Board.

Disconnect the Keypad harness at the Carrier Board.

Step 6

• Disconnect the encoder harness from the Carrier Board.

Disconnect the encoder harness from the Carrier Board.

Step 7

• Disconnect the speaker harness from the Carrier Board and set the speakers aside.

Disconnect the speaker harness from the Carrier Board and set the speakers aside.

Step 8

• Disconnect the alarm light harness from the Carrier Board.

Disconnect the alarm light harness from the Carrier Board.

Step 9

• Loosen (do not remove) the five screws at the top edge of the shield just enough to raise it and slide the shield away with a Phillips #0 screwdriver.

Loosen (do not remove) the five screws at the top edge of the shield just enough to raise it and slide the shield away with a Phillips #0 screwdriver.

Step 10

• Loosen the four screws along each side of the shield with a Phillips #0 screwdriver.

Loosen the four screws along each side of the shield with a Phillips #0 screwdriver.

Step 11

• Remove the four screws at the bottom edge of the shield with a Phillips #0 screwdriver.

Remove the four screws at the bottom edge of the shield with a Phillips #0 screwdriver.

Step 12

• Slide the shield down to disengage the touch controller harness connector.

Slide the shield down to disengage the touch controller harness connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Andre Fisher                     

Member since: 01/23/2020

357 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge                           

Team

                       Cal Poly, Team S7-G9, Paton Spring 2020                        

                                                  Member of Cal Poly, Team S7-G9, Paton Spring 2020 



                    CPSU-PATON-S20S7G9                     


                                            3 Members                     


                                            4 Guides authored