Ge 7 4836B Alarm Clock Am Fm Radio On Off Music Alarm Switch Replacement Repair Guide

Difficulty

Difficult

Steps

9

Time Required

Suggest a time??

Sections

2

• Outer Case
• 5 steps
• On/Off/Music/Alarm Switch
• 4 steps

Flags

1

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

• BackGE 7-4836B

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery Compartment Cover               

• Find the battery compartment on the bottom of the clock radio.
• Using your thumb, push the compartment cover latch toward the battery.
• With the latch pushed in, pull the compartment cover upward to remove it..

Find the battery compartment on the bottom of the clock radio.

Using your thumb, push the compartment cover latch toward the battery.

With the latch pushed in, pull the compartment cover upward to remove it..

1024

Step 2

              Battery               

• Lift the battery from the compartment.
• Pull the battery up and gently disconnect it from the battery connector.

Lift the battery from the compartment.

Pull the battery up and gently disconnect it from the battery connector.

Step 3

              Screws               

• Using a Phillips #00 Screwdriver, unscrew the six 12mm screws from around the bottom of the clock radio.

Using a Phillips #00 Screwdriver, unscrew the six 12mm screws from around the bottom of the clock radio.

Step 4

              LCD Cover               

• Gently pull the liquid crystal display (LCD) cover off.

Gently pull the liquid crystal display (LCD) cover off.

Step 5

              Clock Radio               

• Lift the top off. Two gray, plastic internal pieces will fall out when you do this; set them aside.

Lift the top off. Two gray, plastic internal pieces will fall out when you do this; set them aside.

Step 6

              Battery Wires Wire Tie               

• Using the wire cutters, carefully cut the plastic wire tie.

Using the wire cutters, carefully cut the plastic wire tie.

Step 7

              Speaker               

• Grip the speaker.
• Lift the speaker from the holder.

Grip the speaker.

Lift the speaker from the holder.

Step 8

              Two Screws               

• Locate the two 6mm screws on the PCB.
• Using a Phillips #0 Screwdriver, unscrew the two 6mm screws from the PCB.

Locate the two 6mm screws on the PCB.

Using a Phillips #0 Screwdriver, unscrew the two 6mm screws from the PCB.

Step 9

              Four-Position Switch               

• Locate the four-position switch marked SW101. On the underside of the PCB, there will be 4 soldered pins as pointed at in the picture.
• Apply the hot soldering iron to those four soldered pins to disconnect the four-position switch.

Locate the four-position switch marked SW101. On the underside of the PCB, there will be 4 soldered pins as pointed at in the picture.

Apply the hot soldering iron to those four soldered pins to disconnect the four-position switch.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 1 other contributor 

                    Dominick Giguere                     

Member since: 10/28/2014

848 Reputation

                                      6 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges