Gbc Creative Laminator Gear Replacement Repair Guide

Difficulty

Easy

Steps

4

Time Required

                          15 minutes            

Sections

1

• Gear
• 4 steps

Flags

0

• BackGBC Creative Laminator

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Gear               

• Using the Phillips #2 screwdriver, remove ten 12 mm long screws on the bottom of the device.

Using the Phillips #2 screwdriver, remove ten 12 mm long screws on the bottom of the device.

1024

Step 2

• Open the top of the device, and the inside of the Laminator will be exposed as shown.

Open the top of the device, and the inside of the Laminator will be exposed as shown.

Step 3

• Using the Phillips #2 screwdriver, remove the two 9 mm long screws on the side of the main component that fix the motor in place.
• Pull the motor off of the main internal component to reveal the gear.

Using the Phillips #2 screwdriver, remove the two 9 mm long screws on the side of the main component that fix the motor in place.

Pull the motor off of the main internal component to reveal the gear.

Step 4

• Pull the gear off of the motor.

Pull the gear off of the motor.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    Yujia Tang                     

Member since: 07/11/2018

321 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       IUPUI, Team S1-G1, Wilson Summer 2018                        

                                                  Member of IUPUI, Team S1-G1, Wilson Summer 2018 



                    IUPUI-WILSON-SU18S1G1                     


                                            5 Members                     


                                            2 Guides authored                     

Jim Pruitt - Oct 4, 2022

Reply

Can you tell me where I might find a replacement gear for my GBC H200? I would like to find a brass gear but mine melted and need to find a replacement but no info for the gear. I think it is 17 teeth but not sure about the rest.