Gateway Nv52 Hard Drive Replacement Repair Guide

Difficulty

Very easy

Steps

6

Time Required

                          5 minutes            

Sections

3

• Base Cover
• 2 steps
• Hard Drive Compartment
• 2 steps
• Hard Drive
• 2 steps

Flags

1

Missing Prerequisites

This guide is missing information on how to start the process. Make a prerequisite guide!

• BackGateway NV52

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Base Cover               

• Remove the five identical 3/16" Phillips screws that secures the hard drive and memory cover using a Phillips #0 Screwdriver.

Remove the five identical 3/16" Phillips screws that secures the hard drive and memory cover using a Phillips #0 Screwdriver.

1024

Step 2

• Lift up the base cover from the the top with your hands to a 90 degree angle.
• Remove the base cover and place it in a safe and dry place.

Lift up the base cover from the the top with your hands to a 90 degree angle.

Remove the base cover and place it in a safe and dry place.

Step 3

              Hard Drive Compartment               

• Remove the 1/4" Phillip screw located at the top right of the Hard Drive using a Phillips #0 Screwdriver .

Remove the 1/4" Phillip screw located at the top right of the Hard Drive using a Phillips #0 Screwdriver .

Step 4

• Remove the Hard Drive component from its compartment. To do so, slide the component downward away from the battery pack.
• Lift the Hard Drive to a 90 degree angle and out of its slot.
• Place the Hard Drive in a designated zone.

Remove the Hard Drive component from its compartment. To do so, slide the component downward away from the battery pack.

Lift the Hard Drive to a 90 degree angle and out of its slot.

Place the Hard Drive in a designated zone.

Step 5

              Hard Drive               

• Remove the four identical 1/8" Phillip screws located in every corner of the Hard Drive using the Phillips #0 Screwdriver.

Remove the four identical 1/8" Phillip screws located in every corner of the Hard Drive using the Phillips #0 Screwdriver.

Step 6

• Access to the Hard drive by gently sliding the metal cover away from the Hard Drive.

Access to the Hard drive by gently sliding the metal cover away from the Hard Drive.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Irma Marin                     

Member since: 04/10/2014

605 Reputation

                                      3 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges                           

Team

                       Cal Poly, Team 7-24, Regan Spring 2014                        

                                                  Member of Cal Poly, Team 7-24, Regan Spring 2014 



                    CPSU-REGAN-S14S7G24                     


                                            4 Members                     


                                            18 Guides authored