Difficulty
Very easy
Steps
4
Time Required
5 minutes
Sections
2
- Base Cover
- 2 steps
- Hard Drive Compartment
- 2 steps
Flags
0
BackGateway NV52
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Base Cover
- Remove the five identical 3/16" Phillips screws that secures the hard drive and memory cover using a Phillips #0 Screwdriver.
Remove the five identical 3/16" Phillips screws that secures the hard drive and memory cover using a Phillips #0 Screwdriver.
1024
Step 2
- Lift up the base cover from the the top with your hands to a 90 degree angle.
- Remove the base cover and place it in a safe and dry place.
Lift up the base cover from the the top with your hands to a 90 degree angle.
Remove the base cover and place it in a safe and dry place.
Step 3
Hard Drive Compartment
- Remove the 1/4" Phillip screw located at the top right of the Hard Drive using a Phillips #0 Screwdriver .
Remove the 1/4" Phillip screw located at the top right of the Hard Drive using a Phillips #0 Screwdriver .
Step 4
- Remove the Hard Drive component from its compartment. To do so, slide the component downward away from the battery pack.
- Lift the Hard Drive to a 90 degree angle and out of its slot.
- Place the Hard Drive in a designated zone.
Remove the Hard Drive component from its compartment. To do so, slide the component downward away from the battery pack.
Lift the Hard Drive to a 90 degree angle and out of its slot.
Place the Hard Drive in a designated zone.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 4 other contributors
Tim En
Member since: 01/26/2013
536 Reputation
4 Guides authored
Badges:
14
+11 more badges
Team
Cal Poly, Team 7-24, Regan Spring 2014
Member of Cal Poly, Team 7-24, Regan Spring 2014
CPSU-REGAN-S14S7G24
4 Members
18 Guides authored