Gateway Ne56R27U Screen Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 minutes

Sections

Battery
2 steps
Screen
7 steps

Flags

BackGateway NE56R27u
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Using the spudger, push the orange tab to the unlock position.

Using the spudger, push the orange tab to the unlock position.

1024

Step 2

Lift the battery from its compartment.
When reinstalling, insert back end of battery first, then clicking into place.

Lift the battery from its compartment.

When reinstalling, insert back end of battery first, then clicking into place.

Step 3

              Screen

Using the spudger, remove the protective caps for the screen to expose the screws.
Using the Phillips #000 screwdriver, unscrew the bottom two 1mm screws.

Using the spudger, remove the protective caps for the screen to expose the screws.

Using the Phillips #000 screwdriver, unscrew the bottom two 1mm screws.

Step 4

Using the opening pick in between the front cover and bezel, gently loosen and lift the plastic bezel from the screen and backing.

Using the opening pick in between the front cover and bezel, gently loosen and lift the plastic bezel from the screen and backing.

Step 5

Gently lift the frame of the screen from the top to unhook the frame from the base.
When reassembling, hook the bottom of the screen to the base of the laptop before snapping into place.

Gently lift the frame of the screen from the top to unhook the frame from the base.

When reassembling, hook the bottom of the screen to the base of the laptop before snapping into place.

Step 6

Using the Phillips #000 screwdriver, unscrew the four 1 mm screws in the front corners of the metal frame.
Lift the screen slightly to expose the connector board.

Using the Phillips #000 screwdriver, unscrew the four 1 mm screws in the front corners of the metal frame.

Lift the screen slightly to expose the connector board.

Step 7

Using the spudger, carefully remove the webcam connector from the metal frame.

Using the spudger, carefully remove the webcam connector from the metal frame.

Step 8

Peel the tape covering the display cable, releasing the wire from the metal frame.
Unplug the display cable from the image processing board on the screen.

Peel the tape covering the display cable, releasing the wire from the metal frame.

Unplug the display cable from the image processing board on the screen.

Step 9

Using the Phillips #000 screwdriver, unscrew the four 1 mm screws from the sides of the metal frame.
Remove the screen from the metal frame.

Using the Phillips #000 screwdriver, unscrew the four 1 mm screws from the sides of the metal frame.

Remove the screen from the metal frame.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Piper Moeller

Member since: 01/24/2020

613 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Embry-Riddle Aeronautical University, Team S6-G2, Watkins Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S6-G2, Watkins Spring 2020 



                    ERAU-WATKINS-S20S6G2                     


                                            4 Members                     


                                            10 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team