Difficulty

Moderate

Steps

9

Time Required

                          20 - 25 minutes

Sections

4

  • Battery
  • 2 steps
  • Upper Case
  • 3 steps
  • Motherboard
  • 2 steps
  • Fan
  • 2 steps

Flags

0

  • BackGateway NE52214U

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Make sure to power down and turn off the laptop before proceeding with this guide.
  • Flip over the laptop.

Make sure to power down and turn off the laptop before proceeding with this guide.

Flip over the laptop.

1024

Step 2

  • Slide the tab to the left and hold the tab there.
  • While holding down the sliding tab, remove the battery from the device.

Slide the tab to the left and hold the tab there.

While holding down the sliding tab, remove the battery from the device.

Step 3

              Upper Case
  • After removing the battery, remove 15 7mm screws using the Phillip #1 Screwdriver.

After removing the battery, remove 15 7mm screws using the Phillip #1 Screwdriver.

Step 4

  • Flip over the laptop and open it so the screen is facing you.

Flip over the laptop and open it so the screen is facing you.

Step 5

  • Lift the upper case cover off of the device. Use a prying tool along the edges if necessary.

Lift the upper case cover off of the device. Use a prying tool along the edges if necessary.

Step 6

              Motherboard
  • Remove the twelve 3mm screws using the Phillips #00 screwdriver.

Remove the twelve 3mm screws using the Phillips #00 screwdriver.

Step 7

  • Gently lift and remove the motherboard off of device.
  • This will also remove the fan from the device but it will remain attached to the motherboard.

Gently lift and remove the motherboard off of device.

This will also remove the fan from the device but it will remain attached to the motherboard.

Step 8

              Fan
  • Remove the four 3mm screws attaching the fan to motherboard using the Phillips #00 screwdriver.

Remove the four 3mm screws attaching the fan to motherboard using the Phillips #00 screwdriver.

Step 9

  • Gently lift the fan and disconnect the fan from the motherboard.
  • Remove the fan from the device.

Gently lift the fan and disconnect the fan from the motherboard.

Remove the fan from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Kelsey Rodrigues

Member since: 10/23/2018

495 Reputation

                                      5 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       UMass Dartmouth, Team S1-G1, Simcock Fall 2018                        

                                                  Member of UMass Dartmouth, Team S1-G1, Simcock Fall 2018 



                    UMASSD-SIMCOCK-F18S1G1                     


                                            3 Members                     


                                            10 Guides authored