Difficulty
Moderate
Steps
5
Time Required
5 - 15 minutes
Sections
1
- Touchpad Assembly
- 5 steps
Flags
0
BackGateway NE52203u
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Touchpad Assembly
- Remove 18 6.0 mm Phillips #00 screws from the bottom of the laptop.
- Remove 5 6.0 mm Phillip #00 screws from under cover.
Remove 18 6.0 mm Phillips #00 screws from the bottom of the laptop.
Remove 5 6.0 mm Phillip #00 screws from under cover.
1024
Step 2
- Remove three 2.9 mm Phillips #00 screws from the battery compartment.
Remove three 2.9 mm Phillips #00 screws from the battery compartment.
Step 3
- Separate the bottom panel from the touchpad assembly by inserting a plastic opening tool between them on all four sides.
Separate the bottom panel from the touchpad assembly by inserting a plastic opening tool between them on all four sides.
Step 4
- Pull black ribbon wire from port using tweezers in order to completely separate touchpad assembly from bottom assembly.
Pull black ribbon wire from port using tweezers in order to completely separate touchpad assembly from bottom assembly.
Step 5
- Disconnect the two ZIF ports that attach the touchpad assembly to the motherboard.
- First flip open the flap covering the ribbon using a spudger or fingernail.
- Second gently pull the ribbon away from the port.
Disconnect the two ZIF ports that attach the touchpad assembly to the motherboard.
First flip open the flap covering the ribbon using a spudger or fingernail.
Second gently pull the ribbon away from the port.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Stephen Spees
Member since: 03/20/2015
542 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
Baylor, Team 2-1, Grigsby Spring 2015
Member of Baylor, Team 2-1, Grigsby Spring 2015
BU-GRIGSBY-S15S2G1
4 Members
10 Guides authored