Difficulty

Moderate

Steps

6

Time Required

                          20 minutes

Sections

3

  • Battery
  • 3 steps
  • Monitor
  • 2 steps
  • Webcam
  • 1 step

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

  • BackGateway LT41P10u

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Place the laptop upside down on a flat surface so you can see the battery.

Place the laptop upside down on a flat surface so you can see the battery.

1024

Step 2

  • Pull the two marked tabs towards the outside of the computer to unlock them.

Pull the two marked tabs towards the outside of the computer to unlock them.

Step 3

  • While keeping both of the tabs in the unlocked position, grab the battery and pull outwards, until the battery slides out from the rest of the computer.

While keeping both of the tabs in the unlocked position, grab the battery and pull outwards, until the battery slides out from the rest of the computer.

Step 4

              Monitor
  • Carefully use a spudger to separate the monitor from top panel.
  • Gently remove lower hooks from the hinges. (see second image)

Carefully use a spudger to separate the monitor from top panel.

Gently remove lower hooks from the hinges. (see second image)

Step 5

  • Once you completed separating the monitor from the top panel disconnect the cable shown here in red by raising the cable lock and pulling the wires away.
  • The second image is how it should look once completely disconnected.

Once you completed separating the monitor from the top panel disconnect the cable shown here in red by raising the cable lock and pulling the wires away.

The second image is how it should look once completely disconnected.

Step 6

              Webcam
  • Using a plastic spudger or fingers gently remove webcam hardware from front screen. A gentle heat source can be used to easily remove glued down parts.
  • Once webcam hardware is removed from front screen, it can be removed by hand from the wiring and replaced.
  • Perform these steps carefully as smaller parts are more likely to break.

Using a plastic spudger or fingers gently remove webcam hardware from front screen. A gentle heat source can be used to easily remove glued down parts.

Once webcam hardware is removed from front screen, it can be removed by hand from the wiring and replaced.

Perform these steps carefully as smaller parts are more likely to break.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Patrick Raposo

Member since: 10/21/2017

201 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       UMass Dartmouth, Team S66-G8, Rockett Fall 2017                        

                                                  Member of UMass Dartmouth, Team S66-G8, Rockett Fall 2017 



                    UMASSD-ROCKETT-F17S66G8                     


                                            3 Members                     


                                            12 Guides authored