Difficulty
Moderate
Steps
5
Time Required
5 minutes
Sections
1
- RAM
- 5 steps
Flags
0
BackGateway LT2104u
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
RAM
- Locate the the “L” shaped cover on the back, lower right hand side the device. Using a Philips screwdriver, remove the screw holding it in.
Locate the the “L” shaped cover on the back, lower right hand side the device. Using a Philips screwdriver, remove the screw holding it in.
1024
Step 2
- Gently lift the cover until it detaches from the device.
Gently lift the cover until it detaches from the device.
Step 3
- Gently push the levers on each side of the stick of RAM away from each other until the RAM springs into a 45° angle.
Gently push the levers on each side of the stick of RAM away from each other until the RAM springs into a 45° angle.
Step 4
- Carefully remove the stick of RAM by pulling at the same 45° angle the RAM is currently at until it detaches from the device.
Carefully remove the stick of RAM by pulling at the same 45° angle the RAM is currently at until it detaches from the device.
Step 5
- When inserting the new stick of ram, be sure to insert it at the same 45° angle that the old stick of ram was taken out at. Press the stick of RAM down until it clicks into place.
When inserting the new stick of ram, be sure to insert it at the same 45° angle that the old stick of ram was taken out at. Press the stick of RAM down until it clicks into place.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 6 other contributors
Chris Sullivan
Member since: 03/29/2016
234 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
UMass Dartmouth, Team 7-5, Catania Spring 2016
Member of UMass Dartmouth, Team 7-5, Catania Spring 2016
UMASSD-CATANIA-S16S7G5
3 Members
10 Guides authored
