Difficulty
Difficult
Steps
13
Time Required
5 - 10 minutes
Sections
2
- Battery
- 4 steps
- Screen
- 9 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackGateway ID49C07u
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Battery
- Turn the laptop over so the bottom of the device is facing upwards with the hinge facing away from you.
Turn the laptop over so the bottom of the device is facing upwards with the hinge facing away from you.
1024
Step 2
- Locate the switch on the top left of the laptop labeled with a padlock symbol.
- Flip the switch in the direction of the unlocked padlock symbol.
Locate the switch on the top left of the laptop labeled with a padlock symbol.
Flip the switch in the direction of the unlocked padlock symbol.
Step 3
- Locate the switch that releases the battery and slide it to the right.
Locate the switch that releases the battery and slide it to the right.
Step 4
- While holding the release switch to the right, pull the battery away from you.
While holding the release switch to the right, pull the battery away from you.
Step 5
Screen
- Turn the laptop over and open.
Turn the laptop over and open.
Step 6
- Use the Small metal spudger to remove the small black screw covers in the bottom corners of the screen
Use the Small metal spudger to remove the small black screw covers in the bottom corners of the screen
Step 7
- Use the PH1 Screwdriver to remove the screws
Use the PH1 Screwdriver to remove the screws
Step 8
- Use the small metal spudger to start separating the front plastic cover from the back plastic cover
Use the small metal spudger to start separating the front plastic cover from the back plastic cover
Step 9
- Once there is enough room for you to fit your hand underneath the top plastic cover you can start pealing it back. It will make a lot of popping noises as it unclips when you separate it.
Once there is enough room for you to fit your hand underneath the top plastic cover you can start pealing it back. It will make a lot of popping noises as it unclips when you separate it.
Step 10
- Once the plastic cover is off locate the 4 screws in the corners of the screen and unscrew them
Once the plastic cover is off locate the 4 screws in the corners of the screen and unscrew them
Step 11
- After the screws are out gently flip the screen over onto the keyboard
After the screws are out gently flip the screen over onto the keyboard
Step 12
- Use the tweezers to peal back the tape over the wire connector on the bottom of the screen
Use the tweezers to peal back the tape over the wire connector on the bottom of the screen
Step 13
- Hold the tape back with one hand and pull the connector out
Hold the tape back with one hand and pull the connector out
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 1 other contributor
Ryan Howlett
Member since: 03/06/2017
267 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
UMass Dartmouth, Team S6-G4, Isaacson Spring 2017
Member of UMass Dartmouth, Team S6-G4, Isaacson Spring 2017
UMASSD-ISAACSON-S17S6G4
3 Members
10 Guides authored
