Difficulty
Moderate
Steps
5
Time Required
15 - 30 minutes
Sections
1
- Outer Casing
- 5 steps
Flags
0
BackGarmin StreetPilot c330
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Outer Casing
- At the top of the outer frame, insert the plastic spudger into the groove in the center.
- Lever the frame gently until it pops out of the case.
At the top of the outer frame, insert the plastic spudger into the groove in the center.
Lever the frame gently until it pops out of the case.
1024
Step 2
- Use a Phillips #00 screwdriver to remove the four screws around the screen.
Use a Phillips #00 screwdriver to remove the four screws around the screen.
Step 3
- Gently pull from both ends of the casing to separate the front and back panels.
- Do not force the pieces apart wider than the length of the connecting wires, or you will damage the wiring.
Gently pull from both ends of the casing to separate the front and back panels.
Do not force the pieces apart wider than the length of the connecting wires, or you will damage the wiring.
Step 4
- Gently unplug the white cable connector using either your fingers or tweezers.
Gently unplug the white cable connector using either your fingers or tweezers.
Step 5
- Carefully expose both halves of the device.
- Be sure not to pull the two halves apart further than the black wire can reach.
Carefully expose both halves of the device.
Be sure not to pull the two halves apart further than the black wire can reach.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 16 other contributors
Adrian Leon
Member since: 10/07/2010
173 Reputation
3 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team 22-1, Maness Fall 2010
Member of Cal Poly, Team 22-1, Maness Fall 2010
CPSU-MANESS-F10S22G1
3 Members
4 Guides authored