Difficulty

Moderate

Steps

6

Time Required

                          25 - 30 minutes

Sections

3

  • Battery Disconnect
  • 3 steps
  • Motherboard
  • 2 steps
  • Satellite Antenna
  • 1 step

Flags

0

  • BackGarmin Rino 700

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

In this guide the only special requirements you will need are a TR6 Torx Security screwdriver, a T5 Torx screwdriver, and a spudger. One hazard with this guide is that you have to apply heat during the last step so do so carefully. For more information on soldering connections, please visit this guide. Going forward, you can see how to prevent these issues on our troubleshooting page: Garmin Rino 700 Troubleshooting

What you need

Step 1

              Battery Disconnect
  • Flip the Garmin Rino 700 over so that the underside is facing up.
  • Using the TR6 Torx Security screwdriver, remove the six 9.5 mm screws on the backside of the device.

Flip the Garmin Rino 700 over so that the underside is facing up.

Using the TR6 Torx Security screwdriver, remove the six 9.5 mm screws on the backside of the device.

1024

Step 2

  • Remove the battery cover and set it to the side.

Remove the battery cover and set it to the side.

Step 3

  • Use the spudger to disconnect the battery wire port from the motherboard.

Use the spudger to disconnect the battery wire port from the motherboard.

Step 4

              Motherboard
  • Using the T5 Torx screwdriver, remove the two 6.4 mm screws on the motherboard.

Using the T5 Torx screwdriver, remove the two 6.4 mm screws on the motherboard.

Step 5

  • Using the nylon spudger, lift the motherboard out of its position.
  • Slide the motherboard out of the front panel of the device.
  • Carefully disconnect the motherboard from the panel and remove it out of the device.

Using the nylon spudger, lift the motherboard out of its position.

Slide the motherboard out of the front panel of the device.

Carefully disconnect the motherboard from the panel and remove it out of the device.

Step 6

              Satellite Antenna
  • Gently and delicately heat up the solder holding the antenna port to the motherboard.
  • Carefully remove the antenna with the tweezers and set it aside.
  • Refer to the How To Solder and Desolder Connections for a guide on soldering.

Gently and delicately heat up the solder holding the antenna port to the motherboard.

Carefully remove the antenna with the tweezers and set it aside.

Refer to the How To Solder and Desolder Connections for a guide on soldering.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Abigail Dugan

Member since: 09/28/2021

512 Reputation

                                      5 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Clemson, Team 5-5, Hunter Fall 2021                        

                                                  Member of Clemson, Team 5-5, Hunter Fall 2021 



                    CLEM-HUNTER-F21S5G5                     


                                            4 Members                     


                                            5 Guides authored