Difficulty
Moderate
Steps
7
Time Required
15 - 30 minutes
Sections
2
- Outer Case
- 6 steps
- Antenna
- 1 step
Flags
0
BackGarmin Nuvi 680
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Outer Case
- Flip open the antenna on the back of the device.
- Remove the two 4.42 mm screws on the antenna cover using a T5 Torx screwdriver.
Flip open the antenna on the back of the device.
Remove the two 4.42 mm screws on the antenna cover using a T5 Torx screwdriver.
1024
Step 2
- Remove the antenna cover.
Remove the antenna cover.
Step 3
- The yellow wire is connected to the motherboard, so you cannot disconnect it until you finish opening the device.
- Pull the antenna circuit board out of its case.
The yellow wire is connected to the motherboard, so you cannot disconnect it until you finish opening the device.
Pull the antenna circuit board out of its case.
Step 4
- Insert the pointed end of a spudger into the leftmost slit of the antenna case.
- Push the spudger to the right.
- Slide the antenna case out slowly or you may lose the antenna’s spring. The spring is inside the black plastic that holds the antenna case to the device.
- Slide the antenna case out of the device.
- Reinstallation tip: first reassemble the antenna casing (place antenna back into its plastic cover), and then re-insert the entire assembly back into the GPS body.
Insert the pointed end of a spudger into the leftmost slit of the antenna case.
Push the spudger to the right.
Slide the antenna case out slowly or you may lose the antenna’s spring. The spring is inside the black plastic that holds the antenna case to the device.
Slide the antenna case out of the device.
Reinstallation tip: first reassemble the antenna casing (place antenna back into its plastic cover), and then re-insert the entire assembly back into the GPS body.
Step 5
- Remove the two screws on the back of the outer case using a T5 Torx screwdriver.
- These screws are 10.82 mm long.
Remove the two screws on the back of the outer case using a T5 Torx screwdriver.
These screws are 10.82 mm long.
Step 6
- Gently pull apart the front and back of the device. The front and back are still connected by ribbon cables.
- Starting along the top, separate the front and back of the device by pushing an iPod-opening tool into the crack along each side of the case.
Gently pull apart the front and back of the device. The front and back are still connected by ribbon cables.
Starting along the top, separate the front and back of the device by pushing an iPod-opening tool into the crack along each side of the case.
Step 7
Antenna
- Use a spudger to disconnect the yellow antenna wire from the ZIF connector by opening the brown latch holding the wire in place.
- Remove the antenna.
Use a spudger to disconnect the yellow antenna wire from the ZIF connector by opening the brown latch holding the wire in place.
Remove the antenna.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 7 other contributors
Chris Marzano
Member since: 01/20/2011
968 Reputation
6 Guides authored
Badges:
14
+11 more badges
Team
Cal Poly, Team 5-22, Amido Winter 2011
Member of Cal Poly, Team 5-22, Amido Winter 2011
CPSU-AMIDO-W11S5G22
5 Members
7 Guides authored
Dennis - Jun 30, 2012
Reply
Where can you find the replacment antenna?
All I see is external antennas on the net.
