Garmin Nuvi 2455Lmt Touch Screen Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          2 - 5 minutes

Sections

Back Panel Assembly
3 steps
Touch Screen
2 steps

Flags

BackGarmin Nuvi 2455LMT
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel Assembly

Remove the four 2.5mm screws from the back assembly with a Torx #04 Screwdriver.
Holding the GPS with a free hand while unscrewing the small screws will help stabilize the device.

Remove the four 2.5mm screws from the back assembly with a Torx #04 Screwdriver.

Holding the GPS with a free hand while unscrewing the small screws will help stabilize the device.

1024

Step 2

Use the plastic opening tool on all four sides of the device to open the Garmin Nuvi LMT2455 Back Panel.
To properly remove the back cover assembly pry open both the back and sides of the assembly.

Use the plastic opening tool on all four sides of the device to open the Garmin Nuvi LMT2455 Back Panel.

To properly remove the back cover assembly pry open both the back and sides of the assembly.

Step 3

Open the device carefully being wary of the orange band that is going from the screen to the motherboard.
Remove the orange band by carefully lifting the lip that connects it to the motherboard.

Open the device carefully being wary of the orange band that is going from the screen to the motherboard.

Remove the orange band by carefully lifting the lip that connects it to the motherboard.

Step 4

              Touch Screen

Locate the edge of the screen that fits into the plastic case
To separate the connector, gently push the tip of a spudger under the clip.
Then, swing the clip over to the other side of the socket, so that it lays flat against the cable.

Locate the edge of the screen that fits into the plastic case

To separate the connector, gently push the tip of a spudger under the clip.

Then, swing the clip over to the other side of the socket, so that it lays flat against the cable.

Step 5

Use the plastic opening tool to wedge between the plastic cover and screen.
Using your hands, gently push the front of the screen towards you to push the screen out of the casing.

Use the plastic opening tool to wedge between the plastic cover and screen.

Using your hands, gently push the front of the screen towards you to push the screen out of the casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Torrance Williams

Member since: 09/15/2016

229 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       USF Tampa, Team 2-3, Blackwell Fall 2016                        

                                                  Member of USF Tampa, Team 2-3, Blackwell Fall 2016 



                    USFT-BLACKWELL-F16S2G3                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team