Garmin Nuvi 200W Display Assembly Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          15 minutes            

Sections

2

• Rear Cover
• 4 steps
• Display Assembly
• 1 step

Flags

0

• BackGarmin Nuvi 200W

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

It is important to note, however, that the case and it’s internals require very specific screws, that are small and easy to lose. It is recommended that a magnet or tap is used to secure screws after removal. It is also important to gently remove the back cover, as it will be attached to other interior elements. This connection is sensitive and should be treated as such until the guide shows proper disconnection of this particular cable.

Only basic tools are required, such as screw drivers, and opening tools.

What you need

Step 1

              Rear Cover               

• Peel off the sticker in order to find the two Torx T5 screws.

Peel off the sticker in order to find the two Torx T5 screws.

1024

Step 2

• Remove the two 4mm T5 Torx screws.

Remove the two 4mm T5 Torx screws.

Step 3

• Carefully, using your plastic opening tools find the crease which separates the front and rear covers.
• Once you have a little gap, work it around the whole device with the tool to get separation.
• There is a ribbon cable between the two covers, be very careful when taking them apart to not damage the ribbon.

Carefully, using your plastic opening tools find the crease which separates the front and rear covers.

Once you have a little gap, work it around the whole device with the tool to get separation.

There is a ribbon cable between the two covers, be very careful when taking them apart to not damage the ribbon.

Step 4

• After the case front and rear are separated, carefully lay the two sides down without disconnecting or damaging the orange ribbon cable.

After the case front and rear are separated, carefully lay the two sides down without disconnecting or damaging the orange ribbon cable.

Step 5

              Display Assembly               

• Carefully use the black spudger to lift the white retaining clamp on the display cable ZIF connector.
• Make sure to lift up on the white retaining clamp and not the ZIF connector itself.
• Slide the orange ribbon cable away from the ZIF connector.

Carefully use the black spudger to lift the white retaining clamp on the display cable ZIF connector.

Make sure to lift up on the white retaining clamp and not the ZIF connector itself.

Slide the orange ribbon cable away from the ZIF connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    Clayton Golz                     

Member since: 03/08/2017

128 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       UMass Dartmouth, Team S5-G4, Botvin Spring 2017                        

                                                  Member of UMass Dartmouth, Team S5-G4, Botvin Spring 2017 



                    UMASSD-BOTVIN-S17S5G4                     


                                            3 Members                     


                                            6 Guides authored