Difficulty
Easy
Steps
9
Time Required
15 - 30 minutes
Sections
2
- Battery
- 5 steps
- Light Sensor
- 4 steps
Flags
0
BackGarmin nüvi 3590 LMT
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Turn the device off by pressing and holding the power button on the top left of the device.
Turn the device off by pressing and holding the power button on the top left of the device.
1024
Step 2
- Use the plastic opening tool to separate the tabs on the black back cover of the device by leveraging the tool against the frame around the perimeter of the device.
Use the plastic opening tool to separate the tabs on the black back cover of the device by leveraging the tool against the frame around the perimeter of the device.
Step 3
- Once all of the tabs are popped out, take the back cover off.
- The back cover is a separate piece from the device.
Once all of the tabs are popped out, take the back cover off.
The back cover is a separate piece from the device.
Step 4
- Using the plastic spudger, carefully remove the white tab connected to the battery from the device by pulling the tab in the opposite direction from which it is connected.
Using the plastic spudger, carefully remove the white tab connected to the battery from the device by pulling the tab in the opposite direction from which it is connected.
Step 5
- Use the plastic spudger to lift the battery up and away from the device.
- Do not puncture or bend the battery. Serious health complications could occur.
Use the plastic spudger to lift the battery up and away from the device.
Do not puncture or bend the battery. Serious health complications could occur.
Step 6
Light Sensor
- Using the T5 bit, unscrew the four 5.7mm screws in the four corners of the device.
Using the T5 bit, unscrew the four 5.7mm screws in the four corners of the device.
Step 7
- Leverage the plastic opening tool to pop the tabs between the black screen and the metal frame around the perimeter of the device.
- Do not forcibly separate the two pieces after the tabs have been popped as there are connections between the two pieces that could be torn.
Leverage the plastic opening tool to pop the tabs between the black screen and the metal frame around the perimeter of the device.
Do not forcibly separate the two pieces after the tabs have been popped as there are connections between the two pieces that could be torn.
Step 8
- Using your fingers, pull the red and black wire from the back of the screen.
Using your fingers, pull the red and black wire from the back of the screen.
Step 9
- Locate the red and black wire connected to the circuit board with the round, black, rubbery disc that was connected to the other half of the device (that disc is the light sensor). Gently pull the wire up from the circuit board.
Locate the red and black wire connected to the circuit board with the round, black, rubbery disc that was connected to the other half of the device (that disc is the light sensor). Gently pull the wire up from the circuit board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
David
Member since: 03/11/2015
424 Reputation
3 Guides authored
Badges:
15
+12 more badges
Team
Colorado Springs, Team 4-1, Panko Spring 2015
Member of Colorado Springs, Team 4-1, Panko Spring 2015
UCCS-PANKO-S15S4G1
2 Members
5 Guides authored
