Difficulty

Moderate

Steps

7

Time Required

                          30 minutes

Sections

2

  • Back Cover and AA Batteries
  • 3 steps
  • Keypad Buttons
  • 4 steps

Flags

0

  • BackGarmin GPSmap 60CSx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover and AA Batteries
  • Lift and twist the battery cover release 90 degrees counterclockwise on the back of the device.

Lift and twist the battery cover release 90 degrees counterclockwise on the back of the device.

1024

Step 2

  • Lift battery release up to remove battery cover.

Lift battery release up to remove battery cover.

Step 3

  • Pull AA batteries out.

Pull AA batteries out.

Step 4

              Keypad Buttons
  • Remove the six 10 mm screws on the back of the device with a Phillips #0 screwdriver.
  • Flip the back panel over to view the green electronics board (the PCB) and the PCB covering.
  • Remove the black, yellow, blue, and red wires connected to the PCB with light force.

Remove the six 10 mm screws on the back of the device with a Phillips #0 screwdriver.

Flip the back panel over to view the green electronics board (the PCB) and the PCB covering.

Remove the black, yellow, blue, and red wires connected to the PCB with light force.

Step 5

  • Place the spudger in the bottom right corner of the black PCB cover and pry the corner out.
  • The previous step will need to be done to the other three corners.
  • It is best to do the two bottom corners first.
  • Pull the black PCB board out of the GPSMap 60 CSx.

Place the spudger in the bottom right corner of the black PCB cover and pry the corner out.

The previous step will need to be done to the other three corners.

It is best to do the two bottom corners first.

Pull the black PCB board out of the GPSMap 60 CSx.

Step 6

  • Carefully use a spudger to lift the PCB a few centimeters.
  • Pull the PCB out towards the bottom of the GPSMap 60CSx.
  • This will pull out all the main components including the antenna and the screen.

Carefully use a spudger to lift the PCB a few centimeters.

Pull the PCB out towards the bottom of the GPSMap 60CSx.

This will pull out all the main components including the antenna and the screen.

Step 7

  • Take the front panel and apply light force to the buttons.
  • The buttons are part of one unit and should all pop out at once.

Take the front panel and apply light force to the buttons.

The buttons are part of one unit and should all pop out at once.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors 


                    Thomas Humphrey

Member since: 04/05/2018

537 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Linn Benton Community College, Team S2-G5, Johnson Spring 2018                        

                                                  Member of Linn Benton Community College, Team S2-G5, Johnson Spring 2018 



                    LBCC-JOHNSON-S18S2G5                     


                                            5 Members                     


                                            5 Guides authored