Difficulty

Moderate

Steps

10

Time Required

                          1 hour

Sections

4

  • Touch Display
  • 3 steps
  • Motherboard
  • 4 steps
  • Battery
  • 1 step
  • USB Port
  • 2 steps

Flags

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missed a Step

Oops! This guide is currently missing some important steps.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackGarmin Edge 830

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Touch Display
  • Microwave the iOpener for about 30 seconds. Then place it on top of the screen, and let it sit for about 2 minutes.
  • Repeat this process a second to ensure that the glue is becoming loose.

Microwave the iOpener for about 30 seconds. Then place it on top of the screen, and let it sit for about 2 minutes.

Repeat this process a second to ensure that the glue is becoming loose.

1024

Step 2

  • Use the Jimmy tool carve around the edges of the screen to break the glue seal.

Use the Jimmy tool carve around the edges of the screen to break the glue seal.

Step 3

  • Use the iFixit plastic opening tool to pry open the screen.

Use the iFixit plastic opening tool to pry open the screen.

Step 4

              Motherboard
  • Remove brown and green tape with angled tweezers

Remove brown and green tape with angled tweezers

Step 5

  • Unscrew the three 1 mm screws around the perimeter of the motherboard

Unscrew the three 1 mm screws around the perimeter of the motherboard

Step 6

  • Use the reverse tweezers to gently pull on the silver box on top of the motherboard to remove it from the back cover.

Use the reverse tweezers to gently pull on the silver box on top of the motherboard to remove it from the back cover.

Step 7

  • Locate the wire connector on the motherboard. Slowly release the wires by gently pulling with the blunt tweezers.

Locate the wire connector on the motherboard. Slowly release the wires by gently pulling with the blunt tweezers.

Step 8

              Battery
  • Use the halberd spudger to lift and remove the battery from the back cover.

Use the halberd spudger to lift and remove the battery from the back cover.

Step 9

              USB Port
  • With the T4 screwdriver, unscrew the two 1 mm screws on the green piece located on the inside of the cable connector

With the T4 screwdriver, unscrew the two 1 mm screws on the green piece located on the inside of the cable connector

Step 10

  • Use the halberd spudger to lift and remove the cable connector from the back cover.

Use the halberd spudger to lift and remove the cable connector from the back cover.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Samantha Klopman

Member since: 03/21/2022

293 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       University of Alabama, Team 3-2, Bedsole Spring 2022                        

                                                  Member of University of Alabama, Team 3-2, Bedsole Spring 2022 



                    UA-BEDSOLE-S22S3G2                     


                                            4 Members                     


                                            5 Guides authored