Garmin Edge 830 Battery Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          1 hour            

Sections

3

• Touch Display
• 3 steps
• Motherboard
• 4 steps
• Battery
• 1 step

Flags

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missed a Step

Oops! This guide is currently missing some important steps.

• BackGarmin Edge 830

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Touch Display               

• Microwave the iOpener for about 30 seconds. Then place it on top of the screen, and let it sit for about 2 minutes.
• Repeat this process a second to ensure that the glue is becoming loose.

Microwave the iOpener for about 30 seconds. Then place it on top of the screen, and let it sit for about 2 minutes.

Repeat this process a second to ensure that the glue is becoming loose.

1024

Step 2

• Use the Jimmy tool carve around the edges of the screen to break the glue seal.

Use the Jimmy tool carve around the edges of the screen to break the glue seal.

Step 3

• Use the iFixit plastic opening tool to pry open the screen.

Use the iFixit plastic opening tool to pry open the screen.

Step 4

              Motherboard               

• Remove brown and green tape with angled tweezers

Remove brown and green tape with angled tweezers

Step 5

• Unscrew the three 1 mm screws around the perimeter of the motherboard

Unscrew the three 1 mm screws around the perimeter of the motherboard

Step 6

• Use the reverse tweezers to gently pull on the silver box on top of the motherboard to remove it from the back cover.

Use the reverse tweezers to gently pull on the silver box on top of the motherboard to remove it from the back cover.

Step 7

• Locate the wire connector on the motherboard. Slowly release the wires by gently pulling with the blunt tweezers.

Locate the wire connector on the motherboard. Slowly release the wires by gently pulling with the blunt tweezers.

Step 8

              Battery               

• Use the halberd spudger to lift and remove the battery from the back cover.

Use the halberd spudger to lift and remove the battery from the back cover.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Alden Gibbs                     

Member since: 03/21/2022

265 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       University of Alabama, Team 3-2, Bedsole Spring 2022                        

                                                  Member of University of Alabama, Team 3-2, Bedsole Spring 2022 



                    UA-BEDSOLE-S22S3G2                     


                                            4 Members                     


                                            5 Guides authored