Garmin Edge 1000 Micro Sd Sim Card Tray Holder Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Back Cover
2 steps
Micro SD+SIM Card Tray Holder Slot Flex Cable
1 step

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

BackGarmin Edge 1000
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Cover

Be sure the device is properly powered all the way off before starting the replacement.
Hold the device front side down. Remove the eight T6 Torx screws along the backside of the device.
Pull the front side of the device apart from the back side.

Be sure the device is properly powered all the way off before starting the replacement.

Hold the device front side down. Remove the eight T6 Torx screws along the backside of the device.

Pull the front side of the device apart from the back side.

1024

Step 2

Disconnect the bronze SIM card flex cable from the motherboard with your finger.
Disconnect the battery cord to completely separate the front cover from the back cover of the device with your finger.

Disconnect the bronze SIM card flex cable from the motherboard with your finger.

Disconnect the battery cord to completely separate the front cover from the back cover of the device with your finger.

Step 3

              Micro SD+SIM Card Tray Holder Slot Flex Cable

Take a metal spudger and use force to push the micro USB port out of its socket on the other end.
Use the metal spudger once again to use force and push the SIM card port out of its socket. This will allow you to remove this piece entirely and insert a new charging port into the same place.

Take a metal spudger and use force to push the micro USB port out of its socket on the other end.

Use the metal spudger once again to use force and push the SIM card port out of its socket. This will allow you to remove this piece entirely and insert a new charging port into the same place.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 2 other contributors

                    Taylor McNees

Member since: 10/03/2019

558 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Eastern Washington University, Team S1-G2, Al-Hmeyrat Fall 2019                        

                                                  Member of Eastern Washington University, Team S1-G2, Al-Hmeyrat Fall 2019 



                    EWU-AL-HMEYRAT-F19S1G2                     


                                            3 Members                     


                                            4 Guides authored

Better Introduction#

Introduction#

What you need#

#

#

#

#

#

Team#

#

Better Introduction

Introduction

What you need

Team