Difficulty

Moderate

Steps

7

Time Required

                          10 minutes

Sections

3

  • Back Panel
  • 3 steps
  • Screen Ribbon Cable
  • 2 steps
  • Motherboard
  • 2 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackGarmin Dezl 760LMT

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Using a Torx T6 Screwdriver, remove the ten 7mm screws from the back panel.

Using a Torx T6 Screwdriver, remove the ten 7mm screws from the back panel.

1024

Step 2

  • Using a metal spudger, pry the device apart.
  • To recombine them, line up the two halves of the device and press them together.

Using a metal spudger, pry the device apart.

To recombine them, line up the two halves of the device and press them together.

Step 3

  • Turn the device over, laying it on its back with the screen facing upwards.
  • Lift the front panel away from the silver part of the back panel.
  • Make sure not to rip the ribbon cable that is connected to the screen and the motherboard.

Turn the device over, laying it on its back with the screen facing upwards.

Lift the front panel away from the silver part of the back panel.

Make sure not to rip the ribbon cable that is connected to the screen and the motherboard.

Step 4

              Screen Ribbon Cable
  • Lift the screen opposite where the “GARMIN” logo is located. Remove the clear tape holding the ribbon cable to the motherboard.

Lift the screen opposite where the “GARMIN” logo is located. Remove the clear tape holding the ribbon cable to the motherboard.

Step 5

  • Find and lift the small grey hinge at the end of the ribbon cable.
  • When handling the motherboard, make sure to wear an anti-static wrist strap.

Find and lift the small grey hinge at the end of the ribbon cable.

When handling the motherboard, make sure to wear an anti-static wrist strap.

Step 6

              Motherboard
  • Using a Torx T5 screwdriver, unscrew the six 5mm screws on the motherboard.

Using a Torx T5 screwdriver, unscrew the six 5mm screws on the motherboard.

Step 7

  • Grasp each of the three wires near where it is attached to the motherboard. Lift them upward to detach them.
  • Lift the motherboard from the device.

Grasp each of the three wires near where it is attached to the motherboard. Lift them upward to detach them.

Lift the motherboard from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Ryan Williams

Member since: 09/28/2016

751 Reputation

                                      6 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team 4-2, Passmore Fall 2016                        

                                                  Member of USF Tampa, Team 4-2, Passmore Fall 2016 



                    USFT-PASSMORE-F16S4G2                     


                                            4 Members                     


                                            6 Guides authored

Pierre Delisle - May 7, 2018

Reply

i realy appreciate the video but please tell me where can i find buy the motherboard or others parts for my gps rv-760

Thank you

Pierre Delisle

Québec

Canada