Difficulty
Moderate
Steps
9
Time Required
15 minutes
Sections
2
- Battery
- 4 steps
- Sticky Buttons
- 5 steps
Flags
0
BackGameSir T4 Pro
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Sticky buttons often happen due to the build-up of dirt in the button’s crevices.
What you need
Step 1
Battery
- Using the Phillips 1 screwdriver, gently turn the screw to the left (repeat this step until all four screws are taken out).
Using the Phillips 1 screwdriver, gently turn the screw to the left (repeat this step until all four screws are taken out).
1024
Step 2
- Use your iFixit opening tool to break the seam of the back of your controller.
- Be careful when pulling apart, as the charging port wires are connected to both sides of the controller.
Use your iFixit opening tool to break the seam of the back of your controller.
Be careful when pulling apart, as the charging port wires are connected to both sides of the controller.
Step 3
- Using the plastic spudger, wiggle the connection out of place.
Using the plastic spudger, wiggle the connection out of place.
Step 4
- Apply a slow, but consistent pull to the old 600 maH battery.
- Attach new battery onto the pad
Apply a slow, but consistent pull to the old 600 maH battery.
Attach new battery onto the pad
Step 5
Sticky Buttons
- Remove the three 5mm screws on the motherboard.
Remove the three 5mm screws on the motherboard.
Step 6
- Disconnect all white connectors from the motherboard.
Disconnect all white connectors from the motherboard.
Step 7
- Carefully pull the motherboard away to reveal the front panel.
Carefully pull the motherboard away to reveal the front panel.
Step 8
- Remove the white rubber panel to get access to the buttons.
Remove the white rubber panel to get access to the buttons.
Step 9
- Put a small dab of alcohol on your cotton ball and clean around the area of your sticky button.
Put a small dab of alcohol on your cotton ball and clean around the area of your sticky button.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Madison Puckett
Member since: 09/16/2022
680 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
Western Carolina University, Team 1-4, Virtue Fall 2022
Member of Western Carolina University, Team 1-4, Virtue Fall 2022
WCU-VIRTUE-F22S1G4
4 Members
5 Guides authored
