Difficulty

Moderate

Steps

8

Time Required

                          4 - 5 minutes

Sections

2

  • Battery
  • 4 steps
  • Joystick
  • 4 steps

Flags

0

  • BackGameSir T4 Pro

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Using the Phillips 1 screwdriver, gently turn the screw to the left (repeat this step until all four screws are taken out).

Using the Phillips 1 screwdriver, gently turn the screw to the left (repeat this step until all four screws are taken out).

1024

Step 2

  • Use your iFixit opening tool to break the seam of the back of your controller.
  • Be careful when pulling apart, as the charging port wires are connected to both sides of the controller.

Use your iFixit opening tool to break the seam of the back of your controller.

Be careful when pulling apart, as the charging port wires are connected to both sides of the controller.

Step 3

  • Using the plastic spudger, wiggle the connection out of place.

Using the plastic spudger, wiggle the connection out of place.

Step 4

  • Apply a slow, but consistent pull to the old 600 maH battery.
  • Attach new battery onto the pad

Apply a slow, but consistent pull to the old 600 maH battery.

Attach new battery onto the pad

Step 5

              Joystick
  • Disconnect the rumblers from the motherboard
  • Be careful not to pull the wires while disconnecting rumbler

Disconnect the rumblers from the motherboard

Be careful not to pull the wires while disconnecting rumbler

Step 6

  • Using the screwdriver, remove the 5 mm screws from the motherboard

Using the screwdriver, remove the 5 mm screws from the motherboard

Step 7

  • Using the wedge tool, pop the joystick out

Using the wedge tool, pop the joystick out

Step 8

  • Make sure the square of the joystick matches the square of the pad and pop it in place.

Make sure the square of the joystick matches the square of the pad and pop it in place.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Madison Puckett

Member since: 09/16/2022

680 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Western Carolina University, Team 1-4, Virtue Fall 2022                        

                                                  Member of Western Carolina University, Team 1-4, Virtue Fall 2022 



                    WCU-VIRTUE-F22S1G4                     


                                            4 Members                     


                                            5 Guides authored