Difficulty

Moderate

Steps

9

Time Required

                          15 minutes

Sections

2

  • Battery
  • 4 steps
  • Directional Pad
  • 5 steps

Flags

0

  • BackGameSir T4 Pro

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Directional pads need replacement after wear and tear over time or if it somehow cracks.

What you need

Step 1

              Battery
  • Using the Phillips 1 screwdriver, gently turn the screw to the left (repeat this step until all four screws are taken out).

Using the Phillips 1 screwdriver, gently turn the screw to the left (repeat this step until all four screws are taken out).

1024

Step 2

  • Use your iFixit opening tool to break the seam of the back of your controller.
  • Be careful when pulling apart, as the charging port wires are connected to both sides of the controller.

Use your iFixit opening tool to break the seam of the back of your controller.

Be careful when pulling apart, as the charging port wires are connected to both sides of the controller.

Step 3

  • Using the plastic spudger, wiggle the connection out of place.

Using the plastic spudger, wiggle the connection out of place.

Step 4

  • Apply a slow, but consistent pull to the old 600 maH battery.
  • Attach new battery onto the pad

Apply a slow, but consistent pull to the old 600 maH battery.

Attach new battery onto the pad

Step 5

              Directional Pad
  • To get to the directional pad (d-pad), remove the three 5mm screws on the motherboard.

To get to the directional pad (d-pad), remove the three 5mm screws on the motherboard.

Step 6

  • Disconnect all white connectors from the motherboard.

Disconnect all white connectors from the motherboard.

Step 7

  • Carefully pull the motherboard away to reveal the front panel.

Carefully pull the motherboard away to reveal the front panel.

Step 8

  • Remove the d-pad from the front panel.

Remove the d-pad from the front panel.

Step 9

  • Place your new d-pad in place.

Place your new d-pad in place.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 1 other contributor 


                    Madison Puckett

Member since: 09/16/2022

680 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Western Carolina University, Team 1-4, Virtue Fall 2022                        

                                                  Member of Western Carolina University, Team 1-4, Virtue Fall 2022 



                    WCU-VIRTUE-F22S1G4                     


                                            4 Members                     


                                            5 Guides authored