Gamesir T4 Pro Charging Port Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          6 minutes

Sections

Battery
4 steps
Charging Port
3 steps

Flags

BackGameSir T4 Pro
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Only replace the charging port of your gameSit T4 Pro if the controller is not registering that it is plugged in and you have ruled out the possibility that the charging cord or power supply are the problem.

What you need

Step 1

              Battery

Using the Phillips 1 screwdriver, gently turn the screw to the left (repeat this step until all four screws are taken out).

Using the Phillips 1 screwdriver, gently turn the screw to the left (repeat this step until all four screws are taken out).

1024

Step 2

Use your iFixit opening tool to break the seam of the back of your controller.
Be careful when pulling apart, as the charging port wires are connected to both sides of the controller.

Use your iFixit opening tool to break the seam of the back of your controller.

Be careful when pulling apart, as the charging port wires are connected to both sides of the controller.

Step 3

Using the plastic spudger, wiggle the connection out of place.

Using the plastic spudger, wiggle the connection out of place.

Step 4

Apply a slow, but consistent pull to the old 600 maH battery.
Attach new battery onto the pad

Apply a slow, but consistent pull to the old 600 maH battery.

Attach new battery onto the pad

Step 5

              Charging Port

Use the needle nose pliers to remove the plastic connection from the motherboard.
You may hold the wires for stability, but do not tug on the wires.

Use the needle nose pliers to remove the plastic connection from the motherboard.

You may hold the wires for stability, but do not tug on the wires.

Step 6

Remove the two 5mm screws on the charging port and take out the old charging port.

Remove the two 5mm screws on the charging port and take out the old charging port.

Step 7

Put your new compatible charging port in place.
Make sure to screw in the 5mm screws into your new charing port

Put your new compatible charging port in place.

Make sure to screw in the 5mm screws into your new charing port

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Madison Puckett

Member since: 09/16/2022

680 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Western Carolina University, Team 1-4, Virtue Fall 2022                        

                                                  Member of Western Carolina University, Team 1-4, Virtue Fall 2022 



                    WCU-VIRTUE-F22S1G4                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team