Difficulty
Moderate
Steps
7
Time Required
20 - 40 minutes
Sections
1
- Joystick
- 7 steps
Flags
0
BackGamesir-G3s
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
This guide can also be used to modify the controller with a different type of joystick or to fix drift.
Before we start this guide, please turn off the controller and have a container set aside for the battery.
What you need
Step 1
Joystick
- Use a Phillips #00 screwdriver to remove the seven screws securing the back case.
- Gently pry the rear half of the shell off by hand.
Use a Phillips #00 screwdriver to remove the seven screws securing the back case.
Gently pry the rear half of the shell off by hand.
1024
Step 2
- Battery can be a hazard if punctured.
- Use tweezers to slowly pull on the connector while wiggling until it releases from its port.
Battery can be a hazard if punctured.
Use tweezers to slowly pull on the connector while wiggling until it releases from its port.
Step 3
- The 600mAh rechargeable battery must be stored safely while you continue with repair.
- Peel the battery off of the motherboard.
- Store the battery in a container at room temperature.
The 600mAh rechargeable battery must be stored safely while you continue with repair.
Peel the battery off of the motherboard.
Store the battery in a container at room temperature.
Step 4
- Use a Phillips #00 screwdriver to remove the two screws that connect the motherboard to the case.
Use a Phillips #00 screwdriver to remove the two screws that connect the motherboard to the case.
Step 5
- Remove the bracket that holds the bumpers in place by gently levering it out of its two holders on both sides.
Remove the bracket that holds the bumpers in place by gently levering it out of its two holders on both sides.
Step 6
- Use a Philips #00 screwdriver to remove 6 screws holding the button panel to the controller.
- Remove the button panel from the front case.
Use a Philips #00 screwdriver to remove 6 screws holding the button panel to the controller.
Remove the button panel from the front case.
Step 7
- Grab the joystick from the base and then gently pull it up and off.
Grab the joystick from the base and then gently pull it up and off.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Alex
Member since: 07/06/2022
145 Reputation
1 Guide authored
Badges:
2
Team
York University, Team M-15, Allen Summer 2022
Member of York University, Team M-15, Allen Summer 2022
YORK-ALLEN-SU22SMG15
1 Member
1 Guide authored
