Featured
Featured Guide
Difficulty
Moderate
Steps
9
Time Required
25 - 45 minutes
Sections
2
- Back Cover
- 5 steps
- Galaxy Watch Active2 Core Assembly Removal
- 4 steps
Flags
1
Featured Guide
This guide has been found to be exceptionally cool by the iFixit staff.
BackSamsung Galaxy Watch Active2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Turn off the watch
- Turn off the Galaxy Watch Active2 by pushing and holding the bottom button for approximately 3 seconds. You should feel a short vibration.
- When the “Power off” symbol appears, tap the center of the screen to make it shut down. You should feel a longer vibration for confirmation.
Turn off the Galaxy Watch Active2 by pushing and holding the bottom button for approximately 3 seconds. You should feel a short vibration.
When the “Power off” symbol appears, tap the center of the screen to make it shut down. You should feel a longer vibration for confirmation.
1024
Step 2
Remove the rear screws
- Use a Tri-point Y00 screwdriver to remove the four 4 mm-long screws on the back of the watch.
Use a Tri-point Y00 screwdriver to remove the four 4 mm-long screws on the back of the watch.
Step 3
Separate the back cover from the housing
- Use an opening pick and place it between the plastic back cover and the metal housing near the buttons.
- Push the opening pick into the gap to separate the back cover from the housing.
- Don’t remove the back cover all the way yet. There is a cable connecting it to the motherboard.
Use an opening pick and place it between the plastic back cover and the metal housing near the buttons.
Push the opening pick into the gap to separate the back cover from the housing.
Don’t remove the back cover all the way yet. There is a cable connecting it to the motherboard.
Step 4
Disconnect the sensor array
- Carefully lift the back cover to access the sensor array connector.
- Use a spudger to disconnect the sensor array from the motherboard.
Carefully lift the back cover to access the sensor array connector.
Use a spudger to disconnect the sensor array from the motherboard.
Step 5
Remove the back cover
- Remove the back cover.
Remove the back cover.
Step 6
Disconnect the display and speaker
- Use a spudger to disconnect the display assembly and the speaker.
Use a spudger to disconnect the display assembly and the speaker.
Step 7
Disconnect the barometric sensor, buttons, and mic
- Use a spudger to disconnect the barometric sensor, the buttons, and the microphone.
Use a spudger to disconnect the barometric sensor, the buttons, and the microphone.
Step 8
Lift the core assembly
Place a spudger underneath the motherboard at the top right next to the display connector.
Slightly twist and lever the spudger to loosen the core assembly.
Step 9
Remove the core assembly
- Grab the core assembly and carefully slide it out from under the cables.
- Remove the core assembly.
Grab the core assembly and carefully slide it out from under the cables.
Remove the core assembly.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
Tobias Isakeit
Member since: 03/31/2014
105,397 Reputation
184 Guides authored
Badges:
46
+43 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,772 Guides authored
