Fusion5 5 5 Gen Ii Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 minutes

Sections

Back Cover
1 step
Midframe
2 steps
Motherboard
3 steps

Flags

BackFusion5 5.5 Gen II
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Cover

Hold the device with the screen facing away from you and the back of the device facing you.
Locate the groove at the bottom corner of the device.
Begin prying the back cover of the device off from the groove and working your way around the outside edges of the device.

Hold the device with the screen facing away from you and the back of the device facing you.

Locate the groove at the bottom corner of the device.

Begin prying the back cover of the device off from the groove and working your way around the outside edges of the device.

1024

Step 2

              Midframe

Remove thirteen 3mm Phillips #00 screws from the midframe.
Remove the single 5mm Phillips #0 screw below the camera.

Remove thirteen 3mm Phillips #00 screws from the midframe.

Remove the single 5mm Phillips #0 screw below the camera.

Step 3

Using an opening pick, begin prying one of the top corners to remove the midframe from the device.
Be careful not to damage the cables inside the device when you pry the midframe off.

Using an opening pick, begin prying one of the top corners to remove the midframe from the device.

Be careful not to damage the cables inside the device when you pry the midframe off.

Step 4

              Motherboard

Using tweezers, flip the brown tab securing the ribbon cable.
Make sure to only lift the flap and not the connector socket due to its susceptibility to break off.
Grab the ribbon cable with the tweezers and pull it from its socket on the motherboard.

Using tweezers, flip the brown tab securing the ribbon cable.

Make sure to only lift the flap and not the connector socket due to its susceptibility to break off.

Grab the ribbon cable with the tweezers and pull it from its socket on the motherboard.

Step 5

Remove the two 3mm Phillips #00 screws from the motherboard.

Remove the two 3mm Phillips #00 screws from the motherboard.

Step 6

Grab the motherboard from the right edges.
Flip the motherboard to the left side of the device.
Be careful not to tear the cables attached to the motherboard as you flip the motherboard.
Desolder the red and blue wires to remove the motherboard from the device.

Grab the motherboard from the right edges.

Flip the motherboard to the left side of the device.

Be careful not to tear the cables attached to the motherboard as you flip the motherboard.

Desolder the red and blue wires to remove the motherboard from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Cody Young

Member since: 09/16/2019

197 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Embry-Riddle Aeronautical University, Team S8-G1, Salas Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S8-G1, Salas Fall 2019 



                    ERAU-SALAS-F19S8G1                     


                                            4 Members                     


                                            14 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team