Difficulty

Moderate

Steps

5

Time Required

                          7 - 10 minutes

Sections

1

  • Back Cover
  • 5 steps

Flags

0

  • BackFurbo Dog Camera

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Remove the lid from the top of your Furbo Dog Camera.

Remove the lid from the top of your Furbo Dog Camera.

1024

Step 2

  • Rotate your Furbo so that the bottom faces you.
  • Remove the rubber caps to reveal the four screws on the bottom of the Furbo.

Rotate your Furbo so that the bottom faces you.

Remove the rubber caps to reveal the four screws on the bottom of the Furbo.

Step 3

  • Use a 2.5 mm Flathead screwdriver to remove the four 5 mm screws from the bottom of the Furbo.
  • Use a 2.5 mm Flathead screwdriver to remove the single 5 mm screw under the silver sticker.

Use a 2.5 mm Flathead screwdriver to remove the four 5 mm screws from the bottom of the Furbo.

Use a 2.5 mm Flathead screwdriver to remove the single 5 mm screw under the silver sticker.

Step 4

  • Rotate your Furbo so that the side is facing towards you.
  • Use an opening tool to separate the two plastic coverings.

Rotate your Furbo so that the side is facing towards you.

Use an opening tool to separate the two plastic coverings.

Step 5

  • Once you have separated the two plastic coverings, remove one side by pulling on it and carefully separating it from the adhesive.

Once you have separated the two plastic coverings, remove one side by pulling on it and carefully separating it from the adhesive.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Sarah Teague

Member since: 03/21/2022

265 Reputation

                                      3 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       University of Alabama, Team 1-1, Bedsole Spring 2022                        

                                                  Member of University of Alabama, Team 1-1, Bedsole Spring 2022 



                    UA-BEDSOLE-S22S1G1                     


                                            3 Members                     


                                            6 Guides authored