Difficulty

Very easy

Steps

5

Time Required

                          1 - 3 minutes

Sections

2

  • Battery
  • 2 steps
  • Disk Drive
  • 3 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackFujitsu Lifebook A6110

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • The computer should be fully turned off and disconnected from the power source.
  • Before handling electronic components, you should ground yourself. This will prevent damage to the components from a static charge. You can do this by touching any metal object.
  • Flip your laptop so that the bottom of the laptop is facing up and the hinges of the screen are closest to you.

The computer should be fully turned off and disconnected from the power source.

Before handling electronic components, you should ground yourself. This will prevent damage to the components from a static charge. You can do this by touching any metal object.

Flip your laptop so that the bottom of the laptop is facing up and the hinges of the screen are closest to you.

1024

Step 2

  • Place your fingers under the two clips, and lift them up simultaneously, pulling the cover towards you to remove the battery.

Place your fingers under the two clips, and lift them up simultaneously, pulling the cover towards you to remove the battery.

Step 3

              Disk Drive
  • The disk drive will be located on the side of the computer, on the top-left corner
  • Using a Phillips #1 screwdriver, remove the two 6 mm screws which are located above the disk drive. Remove the screws by turning your screwdriver counter-clockwise.

The disk drive will be located on the side of the computer, on the top-left corner

Using a Phillips #1 screwdriver, remove the two 6 mm screws which are located above the disk drive. Remove the screws by turning your screwdriver counter-clockwise.

Step 4

  • Insert the metal spudger in the gap between the disk drive and the laptop’s body itself, as seen in the picture.
  • Push the spudger down, so that it is behind the drive.
  • Gently pull the disk drive out from the laptop until it unlatches.

Insert the metal spudger in the gap between the disk drive and the laptop’s body itself, as seen in the picture.

Push the spudger down, so that it is behind the drive.

Gently pull the disk drive out from the laptop until it unlatches.

Step 5

  • Once the disk-drive has been unlatched from its slot, pull it gently from the laptop case.

Once the disk-drive has been unlatched from its slot, pull it gently from the laptop case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Cody Moniz

Member since: 10/19/2016

416 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       UMass Dartmouth, Team 3-2, Isaacson Fall 2016                        

                                                  Member of UMass Dartmouth, Team 3-2, Isaacson Fall 2016 



                    UMASSD-ISAACSON-F16S3G2                     


                                            3 Members                     


                                            10 Guides authored