Difficulty

Moderate

Steps

10

Time Required

                          6 minutes

Sections

3

  • Back Case
  • 3 steps
  • Inner Back Shield
  • 4 steps
  • Camera
  • 3 steps

Flags

1

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

  • BackFujitsu Lifebook Stylistic Q584

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Case
  • Remove the white sticker covering the screws (if applicable).
  • Use the PH1 screwdriver to remove the four 2 mm screws from the the backside of the device.

Remove the white sticker covering the screws (if applicable).

Use the PH1 screwdriver to remove the four 2 mm screws from the the backside of the device.

1024

Step 2

  • Insert the plastic opening tool along the seam of the back case.
  • Gently slide the plastic opening tool along the entire seam popping the clips free.

Insert the plastic opening tool along the seam of the back case.

Gently slide the plastic opening tool along the entire seam popping the clips free.

Step 3

  • Carefully lift the back case and remove the smartcard ribbon from the motherboard.

Carefully lift the back case and remove the smartcard ribbon from the motherboard.

Step 4

              Inner Back Shield
  • Remove the ten 3mm screws with a PH00 screwdriver from the shield.

Remove the ten 3mm screws with a PH00 screwdriver from the shield.

Step 5

  • Remove the grey docking station port cover.

Remove the grey docking station port cover.

Step 6

  • Gently slide the plastic opening tool along the entire seam popping the clips free.

Step 7

  • Lift the shield away from the device and remove the fingerprint scanner’s ribbon from the motherboard.

Lift the shield away from the device and remove the fingerprint scanner’s ribbon from the motherboard.

Step 8

              Camera
  • Pull up the cord that connects the battery to the motherboard

Pull up the cord that connects the battery to the motherboard

Step 9

  • Pull the ribbon straight up from the back of the camera board

Pull the ribbon straight up from the back of the camera board

Step 10

  • Remove the single 2mm screw using a PH000 screwdriver from the camera board.

Remove the single 2mm screw using a PH000 screwdriver from the camera board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Connor Stanton

Member since: 09/21/2017

601 Reputation

                                      6 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Washington State, Team S1-G3, Phelps-Hillen Fall 2017                        

                                                  Member of Washington State, Team S1-G3, Phelps-Hillen Fall 2017 



                    WSU-PHELPS-HILLEN-F17S1G3                     


                                            5 Members                     


                                            10 Guides authored