Fujitsu Lifebook P7010D Keyboard Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          10 minutes            

Sections

2

• Battery
• 3 steps
• Keyboard
• 5 steps

Flags

1

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

• BackFujitsu LIFEBOOK P7010D

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Place the laptop upside down on a table.

Place the laptop upside down on a table.

1024

Step 2

• Locate the battery (the grey block). Find the two tabs on one end of the battery near the side of the laptop.
• Using your fingers, press both tabs down at once until they are fully depressed.

Locate the battery (the grey block). Find the two tabs on one end of the battery near the side of the laptop.

Using your fingers, press both tabs down at once until they are fully depressed.

Step 3

• While holding the tabs down, slowly pivot the battery up.
• The battery is now free and safe to pull out.

While holding the tabs down, slowly pivot the battery up.

The battery is now free and safe to pull out.

Step 4

              Keyboard               

• Unscrew three 2.4mm and one 5.7mm screws using a Phillips # 0.
• Unscrew three 1.9mm screws in the battery compartment still using a Phillips # 0

Unscrew three 2.4mm and one 5.7mm screws using a Phillips # 0.

Unscrew three 1.9mm screws in the battery compartment still using a Phillips # 0

Step 5

• Mind the wire connections on the bottom right side of the monitor. They are still connected between the monitor and computer.
• Raise the monitor as you normally would until it pops out by itself. Rotate the left side up and to the right to unhook hinges that may catch on the computer.
• Lay the monitor flat next to the computer.

Mind the wire connections on the bottom right side of the monitor. They are still connected between the monitor and computer.

Raise the monitor as you normally would until it pops out by itself. Rotate the left side up and to the right to unhook hinges that may catch on the computer.

Lay the monitor flat next to the computer.

Step 6

• Using a smaller spudger (like a PX3688), pivot the sound case out above the “F2” and “Insert” buttons.
• Lift the case out and set it aside.
• For the proceeding steps, put on your anti-static wrist strap and attach the metal clip to something metal and grounded in order to protect the delicate circuitry inside the computer.

Using a smaller spudger (like a PX3688), pivot the sound case out above the “F2” and “Insert” buttons.

Lift the case out and set it aside.

For the proceeding steps, put on your anti-static wrist strap and attach the metal clip to something metal and grounded in order to protect the delicate circuitry inside the computer.

Step 7

• Using the same spudger, pry the top of the keyboard up above the “F2” key.
• Turn the computer so that the bottom is facing you.
• The keyboard is connected to a black plastic strip, slowly pull the keyboard and place it to the side.

Using the same spudger, pry the top of the keyboard up above the “F2” key.

Turn the computer so that the bottom is facing you.

The keyboard is connected to a black plastic strip, slowly pull the keyboard and place it to the side.

Step 8

• Disconnect the keyboard by gently pulling on the hard plastic square straight up from the white connector.

Disconnect the keyboard by gently pulling on the hard plastic square straight up from the white connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 

                    Nicholas Ross                     

Member since: 01/20/2012

174 Reputation

                                      7 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       Cal Poly, Team 10-31, Amido Winter 2012                        

                                                  Member of Cal Poly, Team 10-31, Amido Winter 2012 



                    CPSU-AMIDO-W12S10G31                     


                                            5 Members                     


                                            18 Guides authored