Difficulty

Easy

Steps

6

Time Required

                          5 minutes

Sections

1

  • Camera Shell
  • 6 steps

Flags

0

  • BackFujifilm Instax Minion

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Camera Shell
  • Remove the six 4.5 mm #00 Phillips screws from the bottom, left, and right sides.

Remove the six 4.5 mm #00 Phillips screws from the bottom, left, and right sides.

1024

Step 2

  • Use a spudger to remove the film slot guard on the top of the camera.
  • Remove the one 4.5 mm #00 Phillips screw under the slot guard.

Use a spudger to remove the film slot guard on the top of the camera.

Remove the one 4.5 mm #00 Phillips screw under the slot guard.

Step 3

  • Press the release tab on the back of the camera to open the film compartment.
  • Remove the film cartridge within this compartment.

Press the release tab on the back of the camera to open the film compartment.

Remove the film cartridge within this compartment.

Step 4

  • Press the battery cover in and down to remove it.
  • Remove any batteries within.

Press the battery cover in and down to remove it.

Remove any batteries within.

Step 5

  • Use a plastic opening tool to help pry the front and back shells apart.
  • With the camera facing down, remove only the back shell.

Use a plastic opening tool to help pry the front and back shells apart.

With the camera facing down, remove only the back shell.

Step 6

  • Carefully peel the front side of the shell away.
  • As you lift the front shell, be careful to not pull too hard since there is a spring attached to the shell and the camera body.
  • Using a set of tweezers, detach the spring from the body. The spring will retract into the black and gray ring on the front shell.

Carefully peel the front side of the shell away.

As you lift the front shell, be careful to not pull too hard since there is a spring attached to the shell and the camera body.

Using a set of tweezers, detach the spring from the body. The spring will retract into the black and gray ring on the front shell.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Jonnah Lee

Member since: 04/18/2018

473 Reputation

                                      3 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team S18-G6, Livingston Spring 2018                        

                                                  Member of Cal Poly, Team S18-G6, Livingston Spring 2018 



                    CPSU-LIVINGSTON-S18S18G6                     


                                            4 Members                     


                                            10 Guides authored