Difficulty

Difficult

Steps

4

Time Required

                          55 minutes - 1 hour

Sections

1

  • LCD Screen
  • 4 steps

Flags

2

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missed a Step

Oops! This guide is currently missing some important steps.

  • BackFujifilm FinePix Z1

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              LCD Screen
  • Ensure that the camera is charged and not on PowerSave mode.
  • If the camera is charged and on, a faulty LCD Screen could be caused by a scratch or water damage. Also, trauma to the camera could cause the screen to shatter. In any of these cases, the screen will need to be replaced.
  • Make sure that the orange thin cable is appropriately attached.

Ensure that the camera is charged and not on PowerSave mode.

If the camera is charged and on, a faulty LCD Screen could be caused by a scratch or water damage. Also, trauma to the camera could cause the screen to shatter. In any of these cases, the screen will need to be replaced.

Make sure that the orange thin cable is appropriately attached.

1024

Step 2

  • Open the camera by removing the 5 external 4.0 mm screws with the 1.0 flathead.

Open the camera by removing the 5 external 4.0 mm screws with the 1.0 flathead.

Step 3

  • Gently pull the components apart.
  • Remove the 2.0mm screw to the left of the SD card.
  • The LCD screen is located on the back of the circuit board and can be accessed after removing the internal components.

Gently pull the components apart.

Remove the 2.0mm screw to the left of the SD card.

The LCD screen is located on the back of the circuit board and can be accessed after removing the internal components.

Step 4

  • Use the PH00 to pry open the display screen of the camera.
  • Expose the display screen and make sure the cable connecting the screen and the camera are separated. Remember where the cable connection is located to attach the replacement screen.
  • Use the How to Solder and Desolder Connections Guide to remove the screen from the device.

Use the PH00 to pry open the display screen of the camera.

Expose the display screen and make sure the cable connecting the screen and the camera are separated. Remember where the cable connection is located to attach the replacement screen.

Use the How to Solder and Desolder Connections Guide to remove the screen from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Carra

Member since: 01/30/2018

533 Reputation

                                      4 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Baylor, Team S2-G4, Johnson Spring 2018                        

                                                  Member of Baylor, Team S2-G4, Johnson Spring 2018 



                    BU-JOHNSON-S18S2G4                     


                                            3 Members                     


                                            8 Guides authored