Fujifilm Finepix S8200 Selector Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Batteries
3 steps
Rear Housing Cover
3 steps
Selector
1 step

Flags

BackFujifilm FinePix S8200
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Batteries

Turn the camera upside down so you can access the battery chamber.
Make sure that the camera is powered off before opening the battery chamber. Not doing so could damage your memory card.

Turn the camera upside down so you can access the battery chamber.

Make sure that the camera is powered off before opening the battery chamber. Not doing so could damage your memory card.

1024

Step 2

Push the battery chamber latch in the direction of the front of the camera. Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.

Push the battery chamber latch in the direction of the front of the camera. Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.

Step 3

With the battery chamber open, remove the old batteries.
When replacing the batteries, remember that the battery orientation is shown by the + and - marks. Each mark indicates which side of the battery faces up in the chamber.

With the battery chamber open, remove the old batteries.

When replacing the batteries, remember that the battery orientation is shown by the + and - marks. Each mark indicates which side of the battery faces up in the chamber.

Step 4

              Rear Housing Cover

Remove the 4mm JIS #00 screws from the sides and bottom of the camera.

Remove the 4mm JIS #00 screws from the sides and bottom of the camera.

Step 5

Carefully pry away the rear housing cover with the plastic opening tool.

Carefully pry away the rear housing cover with the plastic opening tool.

Step 6

Remove the rear housing cover by carefully pulling it away from the camera.

Remove the rear housing cover by carefully pulling it away from the camera.

Step 7

              Removing Selection Button

To Replace the Selection button, carefully pull the button until the button has been fully detached.

To Replace the Selection button, carefully pull the button until the button has been fully detached.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    Ugent Dailey

Member since: 01/20/2015

119 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       USF Tampa, Team 7-1, Remmell Winter 2015                        

                                                  Member of USF Tampa, Team 7-1, Remmell Winter 2015 



                    USFT-REMMELL-W15S7G1                     


                                            4 Members                     


                                            9 Guides authored

smchous - Jul 28, 2019

preciso dessa peça.. aonde consigo encontrar para comprar? email: smchous@hotmail.com

Introduction#

What you need#

Team#

Introduction

What you need

Team