Fujifilm Finepix S8200 Lcd Screen Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          10 - 15 minutes            

Sections

3

• Batteries
• 3 steps
• Rear Housing Cover
• 3 steps
• LCD Screen
• 1 step

Flags

0

• BackFujifilm FinePix S8200

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Batteries               

• Turn the camera upside down so you can access the battery chamber.
• Make sure that the camera is powered off before opening the battery chamber. Not doing so could damage your memory card.

Turn the camera upside down so you can access the battery chamber.

Make sure that the camera is powered off before opening the battery chamber. Not doing so could damage your memory card.

1024

Step 2

• Push the battery chamber latch in the direction of the front of the camera. Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.

Push the battery chamber latch in the direction of the front of the camera. Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.

Step 3

• With the battery chamber open, remove the old batteries.
• When replacing the batteries, remember that the battery orientation is shown by the + and - marks. Each mark indicates which side of the battery faces up in the chamber.

With the battery chamber open, remove the old batteries.

When replacing the batteries, remember that the battery orientation is shown by the + and - marks. Each mark indicates which side of the battery faces up in the chamber.

Step 4

              Rear Housing Cover               

• Remove the 4mm JIS #00 screws from the sides and bottom of the camera.

Remove the 4mm JIS #00 screws from the sides and bottom of the camera.

Step 5

• Carefully pry away the rear housing cover with the plastic opening tool.

Carefully pry away the rear housing cover with the plastic opening tool.

Step 6

• Remove the rear housing cover by carefully pulling it away from the camera.

Remove the rear housing cover by carefully pulling it away from the camera.

Step 7

              LCD Screen               

• Fold back the LCD screen with the plastic opening tool.
• Remove the cable coming from the LCD screen that goes into the motherboard.

Fold back the LCD screen with the plastic opening tool.

Remove the cable coming from the LCD screen that goes into the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 3 other contributors 

                    Joseph Kelley                     

Member since: 01/15/2015

228 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       USF Tampa, Team 7-1, Remmell Winter 2015                        

                                                  Member of USF Tampa, Team 7-1, Remmell Winter 2015 



                    USFT-REMMELL-W15S7G1                     


                                            4 Members                     


                                            9 Guides authored