Difficulty
Easy
Steps
3
Time Required
5 minutes
Sections
1
- Rear Cover Casing
- 3 steps
Flags
0
BackFujifilm Finepix S1000fd
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Cover Casing
- Use the Phillips PH00 screwdriver to remove all the 0.5mm screws on the side.
Use the Phillips PH00 screwdriver to remove all the 0.5mm screws on the side.
1024
Step 2
- Use the Tri-point Y0 screwdriver to remove the two 0.5mm screws on the horizontal axis.
- Remove the other two 0.5mm screws on the bottom with the PH00 screwdriver.
Use the Tri-point Y0 screwdriver to remove the two 0.5mm screws on the horizontal axis.
Remove the other two 0.5mm screws on the bottom with the PH00 screwdriver.
Step 3
- Once you unscrew all of the screws, carefully remove the rear casing.
- Be careful not to pull the rear casing, otherwise you will rip the ribbon cable.
- Detach the ribbon cable by lifting the tab on the connector.
Once you unscrew all of the screws, carefully remove the rear casing.
Be careful not to pull the rear casing, otherwise you will rip the ribbon cable.
Detach the ribbon cable by lifting the tab on the connector.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Lizzie Eller
Member since: 01/25/2017
422 Reputation
4 Guides authored
Badges:
8
+5 more badges
Team
Cal Poly, Team 8-7, Banghart Winter 2017
Member of Cal Poly, Team 8-7, Banghart Winter 2017
CPSU-BANGHART-W17S8G7
4 Members
10 Guides authored
