Difficulty

Moderate

Steps

4

Time Required

                          25 - 45 minutes

Sections

1

  • Charging Port
  • 4 steps

Flags

2

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackFugoo Tough

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Charging Port
  • Begin by unscrewing the four 10.72mm corner screws using the h2.0 screw driver.
  • Using the h1.5 screwdriver and remove remaining six 5.79mm screws on the front of the speaker.
  • Pull front part of shell away from back part of shell.

Begin by unscrewing the four 10.72mm corner screws using the h2.0 screw driver.

Using the h1.5 screwdriver and remove remaining six 5.79mm screws on the front of the speaker.

Pull front part of shell away from back part of shell.

1024

Step 2

  • Change to the h1.3 head. Remove all 4-5.57mm screws on both speaker covers
  • Pull on the speaker covers, thus removing them
  • Rotate to side the speaker that has the charging port. Remove the 4-5.57mm screws of the facing you.
  • Rotate the speaker 180 degrees and then remove 4-5.57 screws on the side speaker that has the power/bluetooth buttons

Change to the h1.3 head. Remove all 4-5.57mm screws on both speaker covers

Pull on the speaker covers, thus removing them

Rotate to side the speaker that has the charging port. Remove the 4-5.57mm screws of the facing you.

Rotate the speaker 180 degrees and then remove 4-5.57 screws on the side speaker that has the power/bluetooth buttons

Step 3

  • Have back of speaker facing you, remove 5-12.70mm screws using 1/16 flat head screwdriver.
  • Using the plastic opening tool you will be able to wedge back face of speaker off

Have back of speaker facing you, remove 5-12.70mm screws using 1/16 flat head screwdriver.

Using the plastic opening tool you will be able to wedge back face of speaker off

Step 4

  • The circuit board will be revealed, you will notice the various individual speaker connections to the circuit board.
  • Remove blue “clip” from the circuit board.
  • From this point, pull the side panel off gently, exposing the charging port.
  • At this time, you can remove the charging port and replace it.

The circuit board will be revealed, you will notice the various individual speaker connections to the circuit board.

Remove blue “clip” from the circuit board.

From this point, pull the side panel off gently, exposing the charging port.

At this time, you can remove the charging port and replace it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Alicia Edwards

Member since: 01/19/2017

217 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Eastern Washington University, Team 1-2, Mathisen Winter 2017                        

                                                  Member of Eastern Washington University, Team 1-2, Mathisen Winter 2017 



                    EWU-MATHISEN-W17S1G2                     


                                            4 Members                     


                                            5 Guides authored