Fosera Scandle 200 Charging Terminal Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          15 minutes            

Sections

2

• Motherboard Removal
• 5 steps
• Charging Terminal
• 3 steps

Flags

0

• BackFosera Scandle 200

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Motherboard Removal               

• To open up the casing, you will need to unscrew the four Phillips #0 15mm screws which are accessible from the back.

To open up the casing, you will need to unscrew the four Phillips #0 15mm screws which are accessible from the back.

1024

Step 2

• Gently separate the two halves of the casing.

Gently separate the two halves of the casing.

Step 3

• Disconnect the battery from the motherboard by lifting up on the white plastic tab on the top of the connection.
• Gently pull the cord out by the white plastic adapter. Do not pull from the red and black cord.

Disconnect the battery from the motherboard by lifting up on the white plastic tab on the top of the connection.

Gently pull the cord out by the white plastic adapter. Do not pull from the red and black cord.

Step 4

• Unscrew the Phillips four #0 15mm screws to free the motherboard from the casing.

Unscrew the Phillips four #0 15mm screws to free the motherboard from the casing.

Step 5

• Slowly pull the motherboard out of the casing. Make sure the loose battery wire doesn’t get snagged.

Slowly pull the motherboard out of the casing. Make sure the loose battery wire doesn’t get snagged.

Step 6

              Charging Terminal               

• Use caution when using a soldering iron, the tip will be very hot.
• Locate the charging terminal’s three prong connectors on the back of the motherboard.

Use caution when using a soldering iron, the tip will be very hot.

Locate the charging terminal’s three prong connectors on the back of the motherboard.

Step 7

• Start melting the solder on each prong connector individually with the soldering iron.

Start melting the solder on each prong connector individually with the soldering iron.

Step 8

• Use the flat end of the spudger to pry the charging terminal away from the motherboard.

Use the flat end of the spudger to pry the charging terminal away from the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 5 other contributors 

                    David                     

Member since: 09/23/2014

124 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       USF Tampa, Team 12-5, Blackwell Fall 2014                        

                                                  Member of USF Tampa, Team 12-5, Blackwell Fall 2014 



                    USFT-BLACKWELL-F14S12G5                     


                                            4 Members                     


                                            6 Guides authored