Difficulty

Moderate

Steps

13

Time Required

                          15 minutes

Sections

1

  • Power button
  • 13 steps

Flags

0

  • BackFlip Video Ultra

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Power button
  • Unlock the battery cover by sliding the switch to the unlock position.

Unlock the battery cover by sliding the switch to the unlock position.

1024

Step 2

  • Remove the battery cover by sliding it down the camera.

Remove the battery cover by sliding it down the camera.

Step 3

  • Remove the batteries

Remove the batteries

Step 4

  • Slide the black upper casing off from the device.

Slide the black upper casing off from the device.

Step 5

  • Remove the six 1mm screws from the back and upper casing with the Phillips Head screwdriver.

Remove the six 1mm screws from the back and upper casing with the Phillips Head screwdriver.

Step 6

  • Remove the top casing from the bottom to reveal the inner circuit board.

Remove the top casing from the bottom to reveal the inner circuit board.

Step 7

  • When removing the back panel, the rubber buttons will become loose and likely fall off the board. This is normal and can easily placed back on the board once finished.
  • Remove the six 1mm screws with the 1 Phillips head screwdriver.

When removing the back panel, the rubber buttons will become loose and likely fall off the board. This is normal and can easily placed back on the board once finished.

Remove the six 1mm screws with the 1 Phillips head screwdriver.

Step 8

  • Gently separate the circuit board from the casing.

Gently separate the circuit board from the casing.

Step 9

  • Unscrew the single 1mm screw from USB housing unit.

Unscrew the single 1mm screw from USB housing unit.

Step 10

  • Unscrew the 2 1mm screws and gently separate camera wires from plastic casing.

Unscrew the 2 1mm screws and gently separate camera wires from plastic casing.

Step 11

  • Gently pry out the USB housing unit with the Ifxit Opening Tool.

Gently pry out the USB housing unit with the Ifxit Opening Tool.

Step 12

  • Remove the two 1mm screws and separate the circuit board and camera from the plastic casing.

Remove the two 1mm screws and separate the circuit board and camera from the plastic casing.

Step 13

  • Unscrew the camera housing unit from the plastic case.

Unscrew the camera housing unit from the plastic case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Nathaniel Ruf

Member since: 10/18/2016

514 Reputation

                                      5 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       UMass Dartmouth, Team 5-7, Martin Fall 2016                        

                                                  Member of UMass Dartmouth, Team 5-7, Martin Fall 2016 



                    UMASSD-MARTIN-F16S5G7                     


                                            3 Members                     


                                            10 Guides authored