Difficulty
Moderate
Steps
16
Time Required
15 minutes
Sections
1
- Circuit Board
- 16 steps
Flags
0
BackFlip Video Ultra
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Circuit Board
- Unlock the battery cover by sliding the switch to the unlock position.
Unlock the battery cover by sliding the switch to the unlock position.
1024
Step 2
- Remove the battery cover by sliding it down the camera.
Remove the battery cover by sliding it down the camera.
Step 3
- Remove the batteries
Remove the batteries
Step 4
- Slide the black upper casing off from the device.
Slide the black upper casing off from the device.
Step 5
- Remove the six 1mm screws from the back and upper casing with the Phillips Head screwdriver.
Remove the six 1mm screws from the back and upper casing with the Phillips Head screwdriver.
Step 6
- Remove the top casing from the bottom to reveal the inner circuit board.
Remove the top casing from the bottom to reveal the inner circuit board.
Step 7
- When removing the back panel, the rubber buttons will become loose and likely fall off the board. This is normal and can easily placed back on the board once finished.
- Remove the six 1mm screws with the 1 Phillips head screwdriver.
When removing the back panel, the rubber buttons will become loose and likely fall off the board. This is normal and can easily placed back on the board once finished.
Remove the six 1mm screws with the 1 Phillips head screwdriver.
Step 8
- Gently separate the circuit board from the casing.
Gently separate the circuit board from the casing.
Step 9
- Unscrew the single 1mm screw from USB housing unit.
Unscrew the single 1mm screw from USB housing unit.
Step 10
- Unscrew the 2 1mm screws and gently separate camera wires from plastic casing.
Unscrew the 2 1mm screws and gently separate camera wires from plastic casing.
Step 11
- Gently pry out the USB housing unit with the Ifxit Opening Tool.
Gently pry out the USB housing unit with the Ifxit Opening Tool.
Step 12
- Remove the two 1mm screws and separate the circuit board and camera from the plastic casing.
Remove the two 1mm screws and separate the circuit board and camera from the plastic casing.
Step 13
- Unscrew the camera housing unit from the plastic case.
Unscrew the camera housing unit from the plastic case.
Step 14
- With tweezers, remove the microphone and USB connections.
With tweezers, remove the microphone and USB connections.
Step 15
- Unscrew the two 1mm screws from the board shown. Remove screen from circuit board.
Unscrew the two 1mm screws from the board shown. Remove screen from circuit board.
Step 16
- Remove the single 2.1 mm screw and separate camera from the circuit board.
Remove the single 2.1 mm screw and separate camera from the circuit board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Nathaniel Ruf
Member since: 10/18/2016
514 Reputation
5 Guides authored
Badges:
5
+2 more badges
Team
UMass Dartmouth, Team 5-7, Martin Fall 2016
Member of UMass Dartmouth, Team 5-7, Martin Fall 2016
UMASSD-MARTIN-F16S5G7
3 Members
10 Guides authored
