Difficulty
Moderate
Steps
4
Time Required
35 minutes - 1 hour
Sections
1
- Vibration Motor
- 4 steps
Flags
3
Needs More Images
A few more images would make this guide’s procedures crystal clear.
Better Introduction
Improve this guide by completing or revising its introduction.
Missing Details
Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.
BackFitbit Charge HR
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Vibration Motor
- Remove the four 2.9 mm screws from the back of the display using a Torx screwdriver.
- Remove the back cover from the device.
Remove the four 2.9 mm screws from the back of the display using a Torx screwdriver.
Remove the back cover from the device.
1024
Step 2
- Remove the two 2.9 mm Torx screws holding the circuit board in place.
- Carefully pry the board out using an opening tool.
Remove the two 2.9 mm Torx screws holding the circuit board in place.
Carefully pry the board out using an opening tool.
Step 3
- Remove the motherboard assembly from the device.
Remove the motherboard assembly from the device.
Step 4
- Desolder the two soldering points on the motherboard that are connected to the vibration motor.
Desolder the two soldering points on the motherboard that are connected to the vibration motor.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Aekchanin Iamborisut
Member since: 09/20/2021
256 Reputation
2 Guides authored
Badges:
7
+4 more badges
Team
The Citadel Military College of South Carolina, Team 1-2, Eggleston Fall 2021
Member of The Citadel Military College of South Carolina, Team 1-2, Eggleston Fall 2021
CMCSC-EGGLESTON-F21S1G2
3 Members
2 Guides authored
