Difficulty

Moderate

Steps

4

Time Required

                          15 minutes

Sections

1

  • Fitbit Aria 2 Disassembly
  • 4 steps

Flags

Grammar Police

Embrace your inner English teacher and help improve this guide’s grammar!

Bullets!

Better coordination with markups and the color/type of bullets will help make this guide more clear!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackFitbit Aria 2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Preparation
  • Place the scale upside down on a surface that will protect the glass top of the scale and won’t scratch.
  • Remove the battery cover and batteries (if installed).

Place the scale upside down on a surface that will protect the glass top of the scale and won’t scratch.

Remove the battery cover and batteries (if installed).

1024

Step 2

              Remove Screws
  • Remove the label in the battery compartment. You can use a small flat headed screwdriver or similar implement to pry the sticker up. (Try to avoid damaging the sticker too much if possible).
  • Use a Torx T10 screwdriver to remove the two Torx screws and set aside.

Remove the label in the battery compartment. You can use a small flat headed screwdriver or similar implement to pry the sticker up. (Try to avoid damaging the sticker too much if possible).

Use a Torx T10 screwdriver to remove the two Torx screws and set aside.

Step 3

              Unclip Base
  • Using a small flathead screwdriver, starting new the corners, pry away the plastic panel from the glass top.
  • Once the gap is wider use larger pry tools to allow you to pull the bottom section away. You may need to use some force to release the clips.
  • Note there are no cables of components connected to the bottom plate so do not be concerned about ripping delicate cables.

Using a small flathead screwdriver, starting new the corners, pry away the plastic panel from the glass top.

Once the gap is wider use larger pry tools to allow you to pull the bottom section away. You may need to use some force to release the clips.

Note there are no cables of components connected to the bottom plate so do not be concerned about ripping delicate cables.

Step 4

  • Once open necessary repairs can be made.
  • If your issue is regarding inaccurate measurement you can remove the feet by pulling them, then remove the feet mounts using a small flat headed screwdriver to release the three clips.
  • Reassemble the feet and feet mounts outside of the unit then reseat them in the clips.

Once open necessary repairs can be made.

If your issue is regarding inaccurate measurement you can remove the feet by pulling them, then remove the feet mounts using a small flat headed screwdriver to release the three clips.

Reassemble the feet and feet mounts outside of the unit then reseat them in the clips.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Peter Crowther

Member since: 02/17/2018

109 Reputation

                                      1 Guide authored                  



                       Badges:
                       3