Difficulty
Difficult
Steps
4
Time Required
20 - 25 minutes
Sections
1
- Speaker
- 4 steps
Flags
0
BackFirst Act MA2039
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Speaker
- Use a Phillips #0 screwdriver to remove the two 25mm screws that secure back panel to amplifier.
Use a Phillips #0 screwdriver to remove the two 25mm screws that secure back panel to amplifier.
1024
Step 2
- Once screws are removed, lift the panel from the amplifier and feed the battery terminals through holes in battery cartridges.
- Take the panel off and set it to the side.
Once screws are removed, lift the panel from the amplifier and feed the battery terminals through holes in battery cartridges.
Take the panel off and set it to the side.
Step 3
- Use a Phillips #0 screwdriver to remove the four 25mm screws that fasten the speaker to the inside of the amplifier.
Use a Phillips #0 screwdriver to remove the four 25mm screws that fasten the speaker to the inside of the amplifier.
Step 4
- Desolder the black and white speaker wires from the contact board.
- The speaker can now be completely removed from the amplifer.
Desolder the black and white speaker wires from the contact board.
The speaker can now be completely removed from the amplifer.
To reassemble your device, use soldering link provided to solder existing wires onto new speaker, then follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Landon Connolly
Member since: 04/05/2018
332 Reputation
2 Guides authored
Badges:
6
+3 more badges
Team
Linn Benton Community College, Team S1-G5, Johnson Spring 2018
Member of Linn Benton Community College, Team S1-G5, Johnson Spring 2018
LBCC-JOHNSON-S18S1G5
3 Members
6 Guides authored