Fao Schwarz Apex 1 Front Axle Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 10 minutes

Sections

Wheel
2 steps
Front Wheel Springs
3 steps
Front Axle
2 steps

Flags

BackFAO Schwarz Apex 1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Wheel

Position device so that the wheels are on a firm surface .
Using a J1 Screwdriver bit, remove the 11 mm screw from the center of the wheel.

Position device so that the wheels are on a firm surface .

Using a J1 Screwdriver bit, remove the 11 mm screw from the center of the wheel.

1024

Step 2

After removing the 11 mm screw, firmly grip the wheel and pull away from the vehicle.

After removing the 11 mm screw, firmly grip the wheel and pull away from the vehicle.

Step 3

              Front Wheel Springs

Position device upside down so that the screws on the plastic axle pieces can be removed.
Use J1 screwdriver bit to remove two 10 mm screws to remove the plastic axle pieces to make access to the telescopic piston easier.

Position device upside down so that the screws on the plastic axle pieces can be removed.

Use J1 screwdriver bit to remove two 10 mm screws to remove the plastic axle pieces to make access to the telescopic piston easier.

Step 4

Secure a firm grip on the spring and telescopic piston.
Pull telescopic piston holding the spring off the device (this may be difficult).

Secure a firm grip on the spring and telescopic piston.

Pull telescopic piston holding the spring off the device (this may be difficult).

Step 5

Using a tool such as a spudger, gradually maneuver spring off of telescopic piston.

Using a tool such as a spudger, gradually maneuver spring off of telescopic piston.

Step 6

              Front Axle

Carefully turn the vehicle over so that the bottom side is facing upward.
Using a J1 Screwdriver bit, remove the two 10 mm screws that secure the wheel bearing.
Pull the plastic piece that secures the wheel bearing off of the axle.

Carefully turn the vehicle over so that the bottom side is facing upward.

Using a J1 Screwdriver bit, remove the two 10 mm screws that secure the wheel bearing.

Pull the plastic piece that secures the wheel bearing off of the axle.

Step 7

Position the axle entirely upright before lifting away from the vehicle.

Position the axle entirely upright before lifting away from the vehicle.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Carsyn Bernhardt

Member since: 09/07/2018

88 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Appalachian State University, Team S1-G4, Menagarishvili Fall 2018                        

                                                  Member of Appalachian State University, Team S1-G4, Menagarishvili Fall 2018 



                    APSU-MENAGARISHVILI-F18S1G4                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team