Fahrenheit Fht 125Prmr Dial Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Dial
8 steps

Flags

BackFahrenheit FHT 125PRMR
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Dial

Use your fingers or a plastic opening tool to open the side hinges on both sides of the device.

Use your fingers or a plastic opening tool to open the side hinges on both sides of the device.

1024

Step 2

Using a Philips head #2 screwdriver remove the 7mm black screw from the hinge of the device.

Using a Philips head #2 screwdriver remove the 7mm black screw from the hinge of the device.

Step 3

Using the metal spudger, push through the hole the screw was removed from. Doing this will push the copper pin out of the other side.
When the pin is removed the two sides of the device can now separate.
Be sure to collect the spring that is next to the hinge when they are separated.

Using the metal spudger, push through the hole the screw was removed from. Doing this will push the copper pin out of the other side.

When the pin is removed the two sides of the device can now separate.

Be sure to collect the spring that is next to the hinge when they are separated.

Step 4

Using a Philips head #1 screwdriver remove the two 6mm black screws on both sides of the dial panel cover.

Using a Philips head #1 screwdriver remove the two 6mm black screws on both sides of the dial panel cover.

Step 5

Using a Philips head #1 screwdriver remove the two 4mm silver screws on both sides of the dial panel cover.

Using a Philips head #1 screwdriver remove the two 4mm silver screws on both sides of the dial panel cover.

Step 6

Using a Philips head #00 screwdriver remove the 4mm silver screw from the center of the dial.
Remove the dial after the screw is removed with either your hand or a plastic opening tool.

Using a Philips head #00 screwdriver remove the 4mm silver screw from the center of the dial.

Remove the dial after the screw is removed with either your hand or a plastic opening tool.

Step 7

Remove the covering panel by pulling up with your hand.

Remove the covering panel by pulling up with your hand.

Step 8

Using a soldering tool, remove the dial station by carefully desoldering the metal on the connecting pins to the motherboard.
How To Solder and Desolder Connections

Using a soldering tool, remove the dial station by carefully desoldering the metal on the connecting pins to the motherboard.

How To Solder and Desolder Connections

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Nicolas Moreau

Member since: 09/29/2016

180 Reputation

                                      1 Guide authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       IUPUI, Team 2-2, Harley Fall 2016                        

                                                  Member of IUPUI, Team 2-2, Harley Fall 2016 



                    IUPUI-HARLEY-F16S2G2                     


                                            4 Members                     


                                            4 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team