Difficulty

Moderate

Steps

4

Time Required

                          25 minutes

Sections

1

  • Camera
  • 4 steps

Flags

0

  • BackExoPC Slate

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Camera
  • Turn the PC on its back with the screen facing down and pull on the piece of plastic shown in the image. Use your fingernails to prod into the depression where the two plastic covers meet.

Turn the PC on its back with the screen facing down and pull on the piece of plastic shown in the image. Use your fingernails to prod into the depression where the two plastic covers meet.

1024

Step 2

  • Using the 00 Phillips screwdriver remove the two screws in the corners.
  • Using your left hand pull at the exposed section of the PC while simultaneously pushing the right with the thumb of your other hand. This will release the plastic clips allowing back cover to slide off, as shown from the picture
  • When removing the back cover make sure that the ribbon connectors going to the screen are not damaged. Carefully fold over the cover like a book.

Using the 00 Phillips screwdriver remove the two screws in the corners.

Using your left hand pull at the exposed section of the PC while simultaneously pushing the right with the thumb of your other hand. This will release the plastic clips allowing back cover to slide off, as shown from the picture

When removing the back cover make sure that the ribbon connectors going to the screen are not damaged. Carefully fold over the cover like a book.

Step 3

  • Remove the tape covering the metal shield.
  • Remove the 12 screws using the Phillips #00 screwdriver.
  • Dislodge the shield by pulling the prongs away from underneath the battery. The shield should come completely off.

Remove the tape covering the metal shield.

Remove the 12 screws using the Phillips #00 screwdriver.

Dislodge the shield by pulling the prongs away from underneath the battery. The shield should come completely off.

Step 4

  • Use tweezers to disconnect camera cable from motherboard.
  • Remove the Phillips #000 screw that holds the camera in place.
  • Gently remove the camera.

Use tweezers to disconnect camera cable from motherboard.

Remove the Phillips #000 screw that holds the camera in place.

Gently remove the camera.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Aaron Moore

Member since: 10/30/2018

217 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       UMass Dartmouth, Team S2-G1, Peak Fall 2018                        

                                                  Member of UMass Dartmouth, Team S2-G1, Peak Fall 2018 



                    UMASSD-PEAK-F18S2G1                     


                                            3 Members                     


                                            5 Guides authored