Exopc Slate Back Cover And Shield Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 minutes

Sections

Back Cover and Shield
3 steps

Flags

BackExoPC Slate
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Cover and Shield

Turn the PC on its back with the screen facing down and pull on the piece of plastic shown in the image. Use your fingernails to prod into the depression where the two plastic covers meet.

Turn the PC on its back with the screen facing down and pull on the piece of plastic shown in the image. Use your fingernails to prod into the depression where the two plastic covers meet.

1024

Step 2

Using the 00 Phillips screwdriver remove the two screws in the corners.
Using your left hand pull at the exposed section of the PC while simultaneously pushing the right with the thumb of your other hand. This will release the plastic clips allowing back cover to slide off, as shown from the picture
When removing the back cover make sure that the ribbon connectors going to the screen are not damaged. Carefully fold over the cover like a book.

Using the 00 Phillips screwdriver remove the two screws in the corners.

Using your left hand pull at the exposed section of the PC while simultaneously pushing the right with the thumb of your other hand. This will release the plastic clips allowing back cover to slide off, as shown from the picture

When removing the back cover make sure that the ribbon connectors going to the screen are not damaged. Carefully fold over the cover like a book.

Step 3

Remove the tape covering the metal shield.
Remove the 12 screws using the Phillips #00 screwdriver.
Dislodge the shield by pulling the prongs away from underneath the battery. The shield should come completely off.

Remove the tape covering the metal shield.

Remove the 12 screws using the Phillips #00 screwdriver.

Dislodge the shield by pulling the prongs away from underneath the battery. The shield should come completely off.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor

                    Jonathon Cronin

Member since: 10/29/2018

337 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       UMass Dartmouth, Team S2-G1, Peak Fall 2018                        

                                                  Member of UMass Dartmouth, Team S2-G1, Peak Fall 2018 



                    UMASSD-PEAK-F18S2G1                     


                                            3 Members                     


                                            5 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team